I had luck using a lock graphite spray direclty into the lock and then inserting the lock and slightly during the wheel over and over again. Lock was "dry". Insert key and try to turn it. Do this over and over again. Put some graphite on the key and insert. Wiggle wheel. Eventually my key turned and that was almost 2 years ago and no problem since.
If you use too much graphite, key will come out of lock black and so you will need to wipe off excess, if any.
BAttery?, starter? ignition switch?
Turn key off, then back on and crank. There is not reset switch on a Chrysler.
change the Ignition Lock lock switch
it is an ignition problem...could be the ignition switch or the ignition coil if i rember right
Turn the key?
Broken switch, replace it.
Turn key in ignition position II (don't start), wait for 20 or 45 seconds. It should switch off.
Maybe your steering wheel it's keeping the ignition cylinder to turn, so move the steering wheel and at the same time try to turn the key. Maybe you need to replace the ignition cylinder key lock
Unlock the drivers door with the key or insert the key into the ignition switch and turn the switch to the on position will turn off the alarm.
How can I take out the key from the ignition key in a BMW 325i 2001. I can turn on the engine but the key doesn't come out when I turn off.
Normally there is a button or key swith on the dash, if it isn't there or shows you how in the car manual I would say you can't turn it off
Sounds like the ignition switch.