when it is worm you got to keep the throttle down to start
The side of the driver's door on my 2002 Pontiac sunfire is a little hard to read, but I believe it says 30 PSI.
Behind the vibration dampner pully Wrong On a Pontiac sunfire 1998 with the 2.4L it's on the front of the engine tucked aboue the oil filter the bolt is a 5/32 size and it's hard to see
i had it looked at and they said it was the oxygen sensor could that be the problem if so how hard is it to change.
Are you really asking about the speedometer, or are you asking about the cable? It's hard for me to believe that you don't know where your speedo is.
why is my brake pedal hard on 2003 sunfirer
Kind of hard to describe. Pick up a Haynes or Chilton manual. They have good instructions and photos of this job. FriPilot
very hard! I just finished retapping the cam housing bolt holes in my 2000 sunfire. but had to remove the timing chain to get the cam cover and housing off. to get the timing chain off, you have to remove the motor mount bracket off first, then remove the timing cover before getting to the chain. no room to get the bracket bolts off without some assistance to pry the engine to the opposite side.
That filter is hard to get at. Look between the rear of the engine block and the fire wall, near the bottom of the engine on the passenger side.
I have a 1996 Sunfire 2 door hard top that just cost me $160.21 total for the mobile team to come to my residence to replace the windshield. I was quoted as high as $270 so it does pay to call around for estimates.
Replace the fuel pressure regulator, it is leaking fuel past the diaphragm and flooding the motor.
My 1999 Mazda 626 is hard to start any time but then we kick start it then it start fine and dies at any robot will I'm driving My 1999 Mazda 626 is hard to start any time but then we kick start it then it start fine and dies at any robot will I'm driving
Check on the bottom side of the transmission for a plug that may have came unplugged. It will make it shift really hard if it is unplugged.