answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: 1 What is the advantage of sliding window flow control over stop-wait flow control?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are flow-control methods?

Sliding Window Stop and Wait


What is the advantage of sliding window flow control over stop wait flow control?

As compared to stop-and-wait flow control the sliding window flow control has a far better performance. This is because in a wireless environment data rates are very low and noise level is very high, so waiting for an acknowledge for every packet that is transfered does not seem feasible. Thus,Transferring data as a bulk ( Once the medium is allocated ) would yield a better performance in terms of higher throughput. So the choice is sliding window flow control. Sliding window flow control is a point to point protocol assuming that no other entity tries to communicate until the current data transfer is complete by truqchalar


What is the advantage of sliding window flow control over stop-wait flow control?

As compared to stop-and-wait flow control the sliding window flow control has a far better performance. This is because in a wireless environment data rates are very low and noise level is very high, so waiting for an acknowledge for every packet that is transfered does not seem feasible. Thus,Transferring data as a bulk ( Once the medium is allocated ) would yield a better performance in terms of higher throughput. So the choice is sliding window flow control. Sliding window flow control is a point to point protocol assuming that no other entity tries to communicate until the current data transfer is complete by truqchalar


Define error control Describe stop and wait error control?

3.a Explain Stop-and-Wait Error Control and Sliding Window Error Control techniques.


What size is a sliding window for a device that uses the stop and wait flow control method?

A single frame


How do I stop a window from sliding down on Intrigue?

replace the window regulator.


Can the center window be replaced with a rear sliding window on a Ford F-250?

I just shattered the rear sliding window of my Ford F250 and was told by Dave of Quality Glass in LaPorte IN that the current generation of rear sliding windows are designed so the glass cannot be removed to be replaced, so the answer given me was, I need to purchase a new sliding window assembly. I checked into replacing the sliding window with just straight glass and it actually cost me more than aftermarket sliding windows. This is not the definitive answer, but the working answer in my situation.


What are the advantages and disadvantages of onebit sliding window protocol?

Efficiency bandwith onebit sliding window protocol goback N selective repeat


Can you install window film on sliding glass doors?

Yes, you can install window film on sliding glass doors because the sliding doors are still individual and not connected whereas it can disturb the film and come away.


Sliding window protocol using 3 bit sequence number and maximum window size of 4 Starting window positions at A and B before any frames are sent?

i need program C for sliding window protocl


How do you replace sliding window in 92 ford conversion van?

How do you replace sliding driver side rear window in 99 ford e 150 conversion van


How do you replace a rear window in john deere 710J backhoe?

depending on what window your replacing, top rear sliding, middle sliding or lower sliding, the steps are a little different. To get the lower ones out, the manual says; move middle and upper sliding window to full down position, remove "flocked rubber" from both sides, to just above the top of the upper and middle sliding windows, cut the rubber approx. 2" above the the top of the upper and middle sliding windows. Start with the upper sliding window, remove one of the latches and raise the window until it clears the flocked rubber, the upper window can be removed by guiding the side without the latch into the deep portion of the channel until the other side clears the channel and can be removed.