Want this question answered?
check other daewoo with same engine size 1.6,1.8 etc.also check to see if any other manufacturer crosses daewoo engines. for example ford and Mazda use same engines in different cars and trucks like the ranger and the b2000 have the same motor etc. Blocks are from GM so may be a starting point from there.
To check the transmission fluid on a Daewoo Lanos 2000 you have to get to the back side of the engine from underneath. The way we did it was to put the car on a lift.
Have vehicle scanned to determine the problem
Disconnect battery and leave for about 10 min. Then reconnect. The check engine light went away on mine.
need to take it for diagnostic check to find out why its in safe mode
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
Mass Air Flow MAF sensor could be your, problem check that!
check your accelerator...
AnswerThis code is related to the sensor switch on the Air Intake Unit. Check your cable under the hood of the car, make sure it is plugged in, when it is, clear the code and start the engine. The code should be gone. If the problem persists then you might have to replace the cable Owner of a Daewoo Nubira SE
Intermittent starting problems in a Daewoo vehicle might be caused by a number of things. The ignition module is a good place to start. Check for broken or loose wires. Also check the spark plug sensors, the battery, the MAP sensor and the EGR valve.
.The check engine light can be reset, after you install a new air intake, by removing the instrument panel fuse. The fuse can be located in the fuse box
needs put on a diagnostic scanner, that should put the light out