If you have the same transmission as in my 2002 Jeep Grand Cherokee special edition it is located inside the transmission case which can be accessed by removing the lower pan in the transmission.
Shift points are controlled by the engine computers activation of a governor pressure solenoid. The governor pressure activates valves in the transmission that switch gears.
yes , but pressure sensor from older transmission needs to be install in newer one
the check engine light will come on and off and the vehicle will not shift through all the gears properly
No, a defective oil pressure sensor will not harm the engine as long as the oil pressure is what it should be. However, how do you know what the pressure is if the sensor is bad. Replace the sensor so that you can receive a warning if the oil pressure drops below what is optimum.
Your transmission doesn't have an 02 sensor. The o2 sensor monitors engine exhaust to control engine performance. But, dirty transmission fluid is a problem and should be changed before it cause a major and very expensive transmission failure.
The 1983 Cadillac Deville oil pressure sensor can be found on the side of the engine. The oil pressure sensor will be on the left-hand side of the engine.
The oil pressure sensor sends a reading to the gauge so you can moniter the engine's oil pressure. No oil pressure means the engine is in big trouble.
The MAP (Manifold Absolute Presssure) sensor is located under the throttle body and will have an electrical connection as well as a vacuum line going to it. If you follow the air tube from your air filter box to the top of your engine the throttle body lives under there and removing the plastic nut where the air tube terminates will allow you to see the throttle body and the other associated parts. Go to a parts store and ask to see a Map Sensor for your specific engine and you will then be able to immediately identify the thing on your engine. The exact location of the MAP sensor is slightly different depending on the engine that your Jeep has. More Detailed Question = Better Answer. I follow every question I answer so if you have a further question please ask and I'll do my best to help.
The oil pressure sensor is located on the back of the engine, next to the distributor.The oil pressure sensor is located on the back of the engine, next to the distributor.
A sensor has failed, and is reporting the wrong value to the transmission controller. Old transmissions: Probably the vacuum modulator or throttle position sensor. Also check the fluid level. New Transmissions: Output speed sensor, turbine speed sensor, throttle-position sensor, fluid pressure sensor, and sensors on the engine.
The oil level pressure sensor is located on the front of the engine. The oil pressure sensor is just above where the oil pan bolts to the engine.
The engine computer controls a electronic solenoid on the valve body. There is not a mechanical governor in a 1998 Ram transmission.The engine computer controls a electronic solenoid on the valve body. There is not a mechanical governor in a 1998 Ram transmission.