I've fixed two base CD radio displays. They have a single bulb soldered to display circuit board behind clock/radio display. On the first I de-soldered the metal cover and removed to gently raise glass display and expose bulb. Solder connections are actually on outside of this display platform. I clipped leads on outside and threaded leads of new bulb (same as many 12v solder in instrument bulbs), and re-soldered to stubs of old bulb leads. I then reattached metal cover.
After understanding how this was all made, on second unit I again simply clipped leads on exterior of display platform, without removing metal cover. I then used small drills to progressively enlarge bottom of plastic platform where old leads protruded. (I did this by hand, not with a 1/2" drill). Anyway, after enlarging hole enough to extract old bulb, I slipped new bulb back into opening and secured with a little hot melt glue, and re-soldered leads as done in first unit.
Oh by the way, I'm a retired electronics technician.
how to fix the light for the clock radio in a 2003 Pontiac grand am
a picture of the radio would be helpful
You can buy a new one from here: <a href="http://www.cars.baigoods.com/" target="_blank" >Car Electronics</a>
== == i had the same problem on my 2003. i fixed it by taking the radio completely out of the dash and dismantling the front face of it. the lightbulb connector on the screen display was loose. you actually have to do it in your car to get the light to work. just slowly rotate it til it turns on while you have your car on ac. either you can trust it where it is after it comes back on or you can hot glue it.
You can set the clock in your 2003 Ford Escape by holding in the volume button. With the volume button held in the clock display will flash. You can then set the clock by turning the tuning knob.
hold clock+seek for Hours hold clock+discs for minutes
check the fuse under the dash
# Press the TUNE/SEL knob to enter the main menu # Turn the TUNE/SEL knob until set clock appears on the display # Press the TUNE/SEL knob to select set clock # Turn the TUNE/SEL knob to adjust the time # Press the TUNE/SEL knob to update the time.Time updated will appear on the display
Press and hold the HR button until the correct hour appears on the display. Press and hold the MN button until the correct minute appears.
Counter clock wise to loosen.
Check #12 and #15
On the radio there is an icon that looks like a clock. It should be the top right button. Press the button and the time display will appear. Turn the tuner knob to adjust time and then press it to set the time. As soon as you set the time, the clock on the instrument cluster will automatically set.