0
Then fix them. Start by checking the bulbs - those are dual filament bulbs, and it's possible that the filament for the brake lights was compromised. If those check out, see if you have power to the brake light circuit with the brake pedal depressed by using a test light. If you don't have power, what I'd do next is find the relay and test that. Remove the relay, check for power at the 30 post - it should be hot constantly. Then check for power at the 86 post with the brake pedal depressed. If you have power at the 86 pole with the brake pedal depressed and at the 30 pole, then the problem is either the relay itself, or the wiring along the 87 circuit. If you don't have power at the 30 pole, check to see if there's a fuse specifically for the brake lights. If you don't have power at the 86 pole with the brake pedal depressed, the problem is somewhere between the brake pedal and the relay. I'd start with the brake light switch itself if that were the case. Should be located at the top of the brake pedal.
What else can I help you with?
What fuse is for the 2005 Ford Mustang rear brake lights?
What fuse is for the 2005 Ford mustang Rear Brake lights?
What type brake fluid for 2005 Durango?
Dot 3 or Dot 4
What would cause brake lights not to work but all other tail lights are working on a 2005 Chevy Equinox?
Blown fuse, both lights are burnt out, There is a wiring or ground issue.
When i tried to plug a trailer lights to my 2005 Chevy uplander it made my signal light and brake lights stop working what could be the problem?
Short circuit , maybe ????
Where is the fuse for brake lights on a 2005 dodge straus?
can someone help me I can't find where the fus is for brake lights and what is the amp number for a dodge straus 2005
Why are your mondeo 2005 brake lights stuck on?
most times if brake lights are stuck on you have a bad brake light switch on pedal under dash
How do you change the High center brake light bulbs on 2001 Durango?
the back top paneling is just held on with clips, i believe if you start on the ends it's easier.
How do you change brake pads and rotors on 2005 dodge durango with 4 wheel drive?
You will need to remove the tire and wheel from your 2005 Dodge Durango. Remove the brake pad Springs and calipers. Tap the rotors with a hammer to loosen them. Slide the rotors off. Reverse the process to install the new rotors and brake pads.
Were is the fuse for back brake lights for 2005 Ford Crown Victoria?
what number fuse for the break lights
Check Stop Lamp Warning - 2005 Volvo XC70?
The "Check Stop Lamp" warning on a 2005 Volvo XC70 typically indicates an issue with the brake light system. This could be due to burnt-out brake bulbs, a faulty brake light switch, or wiring problems. To resolve the issue, check the brake lights for functionality and replace any burnt bulbs. If the lights are working, you may need to inspect the brake light switch or consult a mechanic for further diagnosis.
Why do your light stay on on your 2005 Subaru Outback?
Brake lights? Check brake light switch for adjustment or replacement
Why is left brake light not working but tail lights work on 2005 Honda civic?
You need to change the bulb. The filiment for the brake light part of the bulb is "open" or burned out. The filiment for the tail light portion will still work.
