Make sure the window is all the way up. If you think it is, lower the window all the way then raise it all the way. Then try the wiper and fluid delivery system.
Well Done. This worked perfectly for me.
typically a washer pump breaks. Replace it. How to replace a washer pump?
The washer pump has probably failed or is plugged with dirt.
either the washer motor has burned out or there is dirt in the washer lines plugging up the washer nozzles.
Type your answer here... front windsheild washers are not working on my 2001 town and country van the wipers are working and back washer is working
Spindle, washer retaining ring , bib washer and bib screw
If a washer pump was replaced on a Jeep Wrangler and is still not working the fuses should be checked. The washer switch should also be checked as it could also be causing the pump not to work.
2.25$ an hour
Probably not. The washer pump is usually on or in the washer fluid reservoir.
I have an '87 Cutlass Supreme Broughm and my rear-defog doesnt work either but my wipers are working. My power door locks, left signal light and power seat do not work either. My 4-way hazards do work though. I am hoping that someone can tell me which fuse this might be,
If washer fuse is blown replace it first ,still washer not working ? One can check motor by following method unplug motor from Engine wiring and connect to separate 12VDC supply from Engine Battery if it does not moved throw & get new one. Maxmagic
I have had the exact same problem with my 1990 wrangler, I found out that unless the handel that allows you to open and shut the rear window is not in the exact closed position and the window is closed tight in place, the wiper will not work but the washer will. Just for fun once I realized this I tried to turn the rear wiper on with the window open and it did not work until I shut it. Hope it works for you.
pressure relief valve isn't working properly