306 hdi 04 starts and runs but does not rev?
Check the plug to the EGR sensors hasn't come loose or a wire broken to it.
1990 240SX runs OK for 30 minutes or so then starts chugging at about 3500 rpm and won't rev any higher Fuel pump?
was told there's a rev counter "unit" somewhere, Haine's manual has nothing, let us know if you sorted it? == Believe rev counter engine speed pickup is from the alternator. Had Rover 218TD with same engine, alternator went and rev counter stopped working. There were 3 wires to alternator, big thick red one, alternator light one and the rev counter feed. Hope this helps peter
The idle can be adjusted at the throttle body via the two adjustment jam nuts on the cable. Be careful not to pull this to tight as the engine will over rev when on cold starts. The idle can be adjusted at the throttle body via the two adjustment jam nuts on the cable. Be careful not to pull this to tight as the engine will over rev when on cold starts. The idle can…
Electronic power control. Could be something wrong with ( ignition, computer or even the throttle if it's electronically controlled. If it starts it's probably not the ignition. If it starts , but runs really bad or shuts itself off then it's probably the computer. If it starts and idles fine , but want rev up or go when you step on the gas then it moght be an electronic throttle issue. There may also be…
97 Monte Carlo when sitting idle and in park you can rev the motor to about 4000 RPM before it starts lopping replaced the tps as a scan tool said it was faulty left to idle on its own it dies?
Stock Harleys come out of the showroom with fitted with a rev limiter that cuts the ignition out at around 5600 rpms. Gets kinda scary when you overtake a truck and halfway there the motor starts to cut out. Can be overcome by fitting an aftermarket ignition module that will rev out to about 7000 rpms.(more than enough for a harley)
What night cause a high pitched squealing sound on a 2004 VW GTI 1.8T for about a minute after it starts?
1990 Toyota pickup truck has problems starting sometimes It clicks and then when it finally starts up it runs sluggish unless you rev the motor Y?
The car revs to its rev limiter for no apparent reason every now and then so you have to turn engine off only way to stop itits a pug 306 dt?
What is wrong 1989 ford F250 460Ci acts like it running out of fuel and stalls won't rev up then dies you let it set for 30 or 40 minutes then it starts and runs fine?
What is wrong with my 1995 Olds Royale it work fine but after a while it starts to rev up and down much worst with the ac and then it sputters and dies mainly in stops but also does it while drivin?
Jesus is given many names in Revelation. Here are some of them: Alpha and Omega (Revelation 1.8 & 22.13) The Almighty (Rev. 1.8) Son of God (Rev.2.18) Lion of the tribe of Juda (Rev.5.5) Root of David (Rev.5.5) The Lamb (Rev.5.13) Lord (Rev.6.10) Lord God Almighty (Rev.11.17) Faithful and True (Rev.19.11) The Word of God ()Rev.19.13) KING OF KINGS AND LORD OF LORDS (Rev.19.16)
In the King James version, the word - seven - in Revelations is in the following associations Rev 1:11 the seven churches which are in Asia Rev 1:12 seven golden candlesticks; Rev 1:16 seven stars: Rev 3:1 seven Spirits of God, Rev 4:5 seven lamps of fire Rev 5:1 seven seals. Rev 5:6 seven horns Rev 5:6 seven eyes, Rev 8:2 seven angels Rev 8:2 seven trumpets. Rev 10:3 seven thunders Rev 11:13 were slain…
What would cause a91 eagle talon to idle fine but rev it up and it works fine then starts to miss then will barely idle then stall then let it sit for 2 min fire it up and it will idle fine?
Rev. Maclean was Norman and Paul Maclean's father, the pastor of the First Presbyterian Church in Missoula, Montana. These were characters in Norman Maclean's novella, A River Runs Through It, but they were also real people. The novella is highly autobiographical. The church that Rev. Maclean pastored is still standing, as is the house that Norman, Paul, Sr. Maclean and his wife lived in. BBehan, residents and native of Missoula
Dim num,rev num= inputbox("Enter a number") If len(num)=4 Then rev=rev*10 + num mod 10 num=num/10 num= left(num,3) rev=rev*10 + num mod 1 Dim num,rev num= inputbox("Enter a number") If len(num)=4 Then rev=rev*10 + num mod 10 num=num/10 num= left(num,3) rev=rev*10 + num mod 10 num=num/10 num= left(num,2) rev=rev*10 + num mod 10 num=num/10 num= left(num,1) rev=rev*10 + num mod 10 msgbox "Reverse Order of the number is "&rev Else msgbox "Number, you entered is not…