0
Too much engine oil could be the problem.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Briggs and stratton engine will only run if you keep pushing the primer bulb?
not getting gas.... needs carb cleaned
Why is fuel dumping into the carb on a Briggs and Stratton 16 hp twin engine and choking it out and flooding the carb causing it to not restart?
The float valve is probably stuck open.
Where is carb adjustment on 22hp v twin Briggs and stratton?
in the tire
Why does a Briggs and Stratton 11hp engine quit after starting?
Could be plugged fuel filter, sticking float:Change fuel filter, clean carb.
Is there a carb filter on Briggs and stratton engines?
yes... near primer bulb
Will a crank shaft on a 12.5 hp Briggs and stratton fit in a 11 hp Briggs and Stratton?
Yes! The motor says its 12.5 hp but that's b.s it's the exact same thing as an 11hp Briggs and Stratton, cept they have a different style carb
Why does your Briggs and stratton engine not start?
bad gas, dirty carb needs new sparkplug. youtube has repair vids on how to do what. user (davidsfarm) has great tips
18.5 HP Briggs and Stratton engine that was running fine then started to die. It will start then it dies What do you think it may be?
dirty fuel filter or water in the bowl of the carb
How do you repair carb on 18 hp intek Briggs and stratton?
Try this site: http://outdoorpowerinfo.com/repairs/
Briggs and Stratton keeps cutting off?
You may have clogged jet in the carb, or in the small fuel filter. Check everything from the tank down to carb, and if necessary take carb apart.
How do you adjust the carburetor on a lawnmower engine?
Go to your local autoparts store and by the rebuild kit according to your carburetor. Inside the box will be an exploded diagram of the carb which will make it relativly simple to rebuild First of all what kind of engine do you have. Briggs and Stratton or Tecumseh. If you have a Briggs & Stratton engine the factory setting on the little black screw is 1 turn out, Tecumseh engines 'usually' do not have adjustments. hope this helps
Why will the engine only run when you pour gas in the carburetor of the Briggs and stratton engine?
if the engine only runs when gas is poured into the carb it is generally caused by plugged jets and/or stuck needle in the seat. if it has been sitting for a length of time the fuel has either crystalized causing the plugging or the ethanol has caused a problem. if it is a new unit, briggs recommends tapping the carb lightly with a hammer to loosen the needle in its seat. for one reason or another the engine is not getting fuel through the carb
