answersLogoWhite

0

You may have clogged jet in the carb, or in the small fuel filter. Check everything from the tank down to carb, and if necessary take carb apart.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Can you take off the over-speed protection on a Briggs and stratton?

check you tube under removing the govenor on a Briggs and stratton


Why does your Briggs and Stratton 11.5 hp engine backfire?

Timing is off ...


What is the cross reference for Briggs and Stratton part number 691656?

The Briggs and Stratton part number 691656 is commonly cross-referenced with part number 798452. This part is typically a replacement for the fuel shut-off valve used in various Briggs and Stratton engines. Always verify compatibility with your specific engine model before purchasing.


How do you pull a flywheel off an 8 horse power Briggs and stratton engine?

use a wheel puller


How do you drain gasoline from Briggs and stratton lawn mower?

The way to drain gasoline from a Briggs and Stratton lawn mower is to take the oil cap off and drain the oil. From there, run a rubber hose into the drain and siphon the rest of the oil and gas out.


How do you take off the carb on a Briggs and stratton law mower?

There are two bolts holding it on to the block. You may have to remove some shrouds to get to it.


18 HP Briggs and Stratton lawn tractor will not shut off?

check your wiring harnes to your starter. make sure it is not connected backwards


How do you get the fly wheel off a Briggs and stratton 12.5cc?

You need to have a pulling tool like a steering wheel puller or a t-type puller.


How do you remove choke knob on Briggs and stratton?

To remove the choke knob on a Briggs and Stratton engine, first, ensure the engine is off and cool. Locate the choke knob, which is typically attached to a lever or rod. Depending on the model, you may need to unscrew a retaining nut or simply pull the knob off if it's designed to slide off. Be cautious not to damage any connected components during the removal process.


How do you set the timing dots 5 hp Briggs and Stratton?

Both marks must FACE each other and cannot be off by even one tooth.


How do you mount a Honda engine to a Briggs and Stratton compatible mower or edger?

If it's compatible just take one off and put the other in it's place.


How do you check oil in Briggs and stratton 12.5hp motor?

With the engine off for at least 15 minutes, remove the dipstick and look to see if the oil is at the full mark.