Threaded end goes to carburetor. Fuel flows into 5/16" hose fitting and out threaded end.
1978 mustang
counterclockwise
Not unless you can make universal mounts for the transmission, and you will have to figure the dimensions for the transmission and if it will fit JUUUUST right in it.
They make adapters for most every application, just check offset before dropping a bundle.
You can "buy" or atleast adopt a mustang from the Bureau of Land Management. The starting cost is actually a bid of $125. Before you can place a bid on a horse you have to fill out an application and make sure you meet the requirements that are given on the application and/or website.
4 cylinder and V6 engines - CLOCKWISE V8 engine - COUNTERCLOCKWISE
i have a 00 mustang with a 4.6l gt. i need to pull off the pully tentionere. but i dont know what direction the bolt should be turn to losen it up. does any one know what direction.
Take the distributor cap off an crank the engine or turn the engine by hand clockwise and note the direction of the distributor rotor.
Yes but they utilize two different types of induction styles and heads, the 2000 being the better. Go to www.supersixmotorsports.com and they will point you in the right direction.
Clockwise , firing order 1 - 3 - 4 - 2
what is meant by IAT. The IAC is located right in front of the throttle body. The Intake Air Temprature sensor is threaded into the cylinder number FIVE intake runner in the lower intake manifold.
Go to a Ford service department. They will either have the manual or point you in the right direction.