answersLogoWhite

0


Best Answer

Check the power going to the HEI. I suspect you are not getting power to it. Obtain a 12V circuit tester and backtrack the power feed to the HEI. I hope this helps you. Mark check for a fuse in the fuse block.

User Avatar

Wiki User

โˆ™ 2005-11-29 21:45:38
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides

๐Ÿ““
Create a Study Guide

Add your answer:

Earn +20 pts
Q: 85 z28 305fi I have no spark. replaced hei coil and pickup coil I had the spark module checked and it was fine any ideas would be great?
Write your answer...
Submit
Related questions

Will a bad ignition module for a 96 S10 pickup make it stall and what does it do?

Yes, My ignition module was bad, I experienced intermittent stalling. My mechanic replaced and it stopped.


Why does your coolant light in your 2000 Chevy pickup keep coming on even after you have had it checked and there was no problem?

The sensor may be defective/broken. I would have that checked or replaced.


How many coils or spark on a 1992 Chevy 305 4x4 pickup replaced cap and pickup coil still no spark?

I would replace the ignition module in the distributor.


Why would there be no spark when I have already replaced the coil the crank position sensor and the ignition module on a 1987 Nissan d21 pickup with 3.0 engine?

The computer maybe fubar(no good)? have you checked the plug wires distributor cap and rotor? could be the distributor its self or possably the pick up coil


Your 93 lumina runs great but like the flip of a switch it will miss and not have mutch power I replaced just about everything?

Have the ignition module and coil packs checked.


What should be checked out on used pickup trucks before purchase?

Some thing's to check on all used vehicles before purchase would be how old it is and how many miles are on it. Also inquire about what parts have been replaced and when they were replaced.


Where is the pcm module for a 1997 Chevy pickup?

where is the pcm module located on my 1997 Chevy truck


96 sunfire will not fire had ignition module checked its good replaced crank sensor still not firing?

check the wire harness that connects to the engine block, on the back


Why if you replaced the cap and rotor spark plugs and wires ignition coil and ignition control module in the disributor do you still not get spark at the spark plugs?

== == check that you are getting power to the distributor. i am assuming you are talking about a earlier model vehicle Have you checked the ecm relay? maybe the pickup coil assy.


Nissan D21 z24 Pickup It cranks won't start no spark getting plenty of fuel just replaced ignition module still won't start?

have you replaced and or tested both coils? are you getting no spark on the intake and the exaust sides?


Brand new battery in 1994 Chevy K1500 turns over wont start?

Have you checked the ignition control module? Have you checked the ignition control module?


Why would blinkers still not work after you checked all fuses and replaced the blinker lever?

in mark 8's they use a controler to make flashers flash. this module has gone bad


Daytimelamps low beams not working high beams are replaced bubls relay switch and turn singnal light switch what could the problem be?

Have you checked the daytime running light module?


What is an air bag module?

IT's a module that controls the Deployment of the air bag & needs 2 b replaced when a new air bag is replaced.


Why would a 1993 Ford Escort still die after about 10 miles when the fuel pump has been replaced?

Have the ignition module checked out and find a new mechanic. Also change the fuel filter.


I have a 1988 Chevy Cavalier. I replaced the Alternator and Battery and also changed a linkable fuse between the alternator and battery. The test still reads no output to alternator. Any ideas?

?ignition control module/pickup


What should you do if you replaced brake pads and calibrators and still severe vibration occurs?

You should have your rotors checked and possibly turned or replaced as necessary You should have your rotors checked and possibly turned or replaced as necessary


89 Chevy pickup with a 5.0 liter. truck will not start. plugs have no fire to them but the coil is producing fire. what could be the problem?

possibly the wire from the coil to the cap, or a cracked distrib. cap, or a worn rotor, have you checked your ignition module?


Where is the Location of ignition control module Dodge ram pickup 1500?

in the computer


Will 88chev pickup transmission fit into a 2002 chev pickup?

No, because the transmission control module and speedometer will not line up, so it will not work.


How do you remove the ignition module on a 1988 ford f-250?

how do you remove the ignition control module on a 1988 ford f-250 pickup?


I replaced the ignition module and coil packs and need to know what sends the signal to the module?

sounds like we are having the same type of issue, I replaced ignition Module and coil pack, and still no spark the last thing to change is the Computer.


Where is the alarm module located on a 1999 Ford Ranger?

it is not an alarm module it is called a G.E.M. module,and it located behind the radio in the dash.and to replaced it has to be reprogrammed


What causes a 2000 Ford Focus to stall at idle while in drive and misfire Have replaced O sensor and checked for vacuum leaks?

most 2000 model year focus have a fuel delivery module recall.


Why wont the ac fan come on for my 95 deville. I've checked the fuses and replaced the relay. Test light reveals no power coming to the fan at all. What am I missing?

blower module on blower/ evap case