answersLogoWhite

0


Best Answer

You may need to check your idle air control valve on the tbi or check for
vac leaks

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 88 Z24 idles at 3000rpm computer IAC TPS changed and intake cleaned what the problem?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How have laptops changed society?

Laptops allow people to bring the computer to the problem, instead of the problem to the computer. This allows much greater use of computers to solve the problems of society.


Chevy Beretta blowing out black smoke?

i had this problem recently i cleaned the egr valve and changed the maf senor the gas and air mixture is off the gas is burning rich


Your gmc z71 runs 15min and dies?

I had the same problem. Not sure if I fixed the problem, but I changed the stereo and it seemed to work. It had a custom stereo. If that's not the problem, it might be your computer module.


Can You Reset computer on Mazda b2200?

How do you reset computer on 1989 Mazda B2200 PU truck? We seem to be having a key turn loop on computer and after so many starts the truck starts stalling out. Have cleaned computer 2 times now and problem seemed to go away but after similar time period usually a week the problem started again.


What is the most likely problem if a 1960 Cadillac charging lamp stays on until 3000rpm?

Sounds like the brushes need to be replaced. Find a shop that can check your regulator, and who can rebuild your generator.


Have a 93 Chevy sub and changed plugs and cleaned injectors and it starts but dies after about 5 sec any help jbsmobiledjyahoocom?

This is another classic example of why you don't just throw parts at a problem. Most likely you have a problem sensing the fact that the engine is running. Typically electric fuel pumps only run for a few seconds when you first turn on the key. Then, if the computer detects that the engine is running, ANOTHER circuit causes the fuel pump to continue running. I'd start with a computer diagnostic scan to see if the computer has detected any problems with the electronic circuits.


Why wont your zwinky profile load?

well i have the same problem on my computer after i cleaned my computer and erased everthing that i didnt need about 2 days later i tyed and forgot then i minimised it and opened it back up then it worked.... username is lyssar97 im a girl


Why would a 95 3.4 liter firebird start then die immediately?

The most likely cause of this problem is that the computer has been changed and the security system is shutting it down. If this is not the case then possibly the ignition switch has been changed and the key coding is not a correct match for the computer.


Why does engine die on Ford Taurus when turning right?

i had the same problem on my Taurus 06. check the battery and it's connections, something is loose. i have changed the battery and cleaned the the terminals. every thing turned ok


What else could cause sudden high oil pressure in your 92 Chevy G20 have changed the oil and filter and dropped the pan and cleaned?

This is an unusual problem. Best to start with a new gage to verify the oil pressure.


Your Merc Mystique appears to have fuel problem you had injectors cleaned fuel filter changed plugs and wires changed it will run and stop after 200 miles but then start right back?

I suspect fuel pump or fuel pump relay problem. Try the relay first they can be tempermental and shut off whenever they want to. then if no luck check wires and connectors for the fuel pump and have it pressure tested.


Vw golf Engine cuts out at traffic lights?

Had this problem on a 1.4 se 1996. Seemed to be cured by the fuel idler valve being cleaned out. Had this problem on a 1.4 se 1996. Seemed to be cured by the fuel idler valve being cleaned out. Had this problem on a 1.4 se 1996. Seemed to be cured by the fuel idler valve being cleaned out.