It depends, not all Cadillac models had them
Where is the engin temperature gauge sensor located on the 1999 cadillac catera?
Reset a fuel gauge? There is not reset for a fuel gauge.
The 1999 Cadillac normal coolant temperature gauge reading should be 180 degrees. A 195 degrees thermostat could be used, causing the temperature gauge to read 195.
If the fuel gauge is not operating on your 1994 Cadillac Eldorado touring coupe, you might have an issue with the sensor or with the fuse for the fuel gauge. You will need to check your electrical system first.
The current value of an ithica gauge over under with vented rib barrel and auto injectors is $1200.
Take it to Pep Boys
Transmission problem. Seek professional help.
With engine running 13.8-14.2
If you problem is that the gauge shows oil pressure with the engine off, you have a gauge or sending unit failure.
The speed sensor for a 1990 Cadillac Deville is located on the side of the transmission. Look for a 2 wire plug with 18 gauge wire.
The Catera transmission does not have a dip stick or gauge to check the oil. The transmission is a sealed unit, there is no need to add oil.
7 for the instrument cluster 9 and 10 for highbeam headlamps.
on top of the engine in the back " not for beginings" the upper intake must be removed!
Connect a fuel pressure gauge to the schrader valve located on the fuel rail that feeds the fuel injectors.
Connect a freon gauge and freon can to the low side ac port. Start the engine and turn the ac on high. Open the valve to allow the freon to flow until the gauge reads full.
Sounds like the charging system has failed. Have the system tested by your local auto parts store, they will do this for no cost.
Connect a freon gauge and tank to the low side ac port of the 97 DeVille. With the engine running and the ac on high, open the freon valve. Shut the valve when the ac gauge reads full.
Try to start your car with the new cluster, and when it dies leave the key alone and wait for the "Theft System" light to stop blinking. For me it stayed on, others I've heard it turns off, either way it wasn't blinking. This usually takes about 10 minutes. Turn the ignition off and remove your keys for about a minute, then reinsert and start your car. This is caused by the ECU cutting off your fuel injectors because it thinks you're stealing the car. Allowing the light to blink for 10 minutes (or until it stops blinking) resets the anti-theft section of the ECU so it will let your car start.
oil pressure switch sends message to oil pressure gauge in dashboard,telling what the oil pressure in engine is
well...the SNOOP DEVILLE is by far the best caddy on the road. it's bumpin!! the trumpet!! 1990 was a long time ago, if your AC gauge isn't showing up you should just fire it. YOU'RE FIRED!!
There are many reasons why the brake light will blink on a car. One such reason is if it is time for the brake system to be serviced. Another reason for the blinking brake light could be low brake fluid.
By any chance are you referring to the word "THEFT" that blinks in your gauge cluster when the Explorer is shut off and locked up ? That indicates that your alarm system is armed .