0
What else can I help you with?
Why will your 1985 Pontiac trans am 305 not start with the clutch pressed - started fine earlier - acts as if the clutch is not pressed - same symptoms with and without the clutch pressed.?
There is a switch mounted under the dash above the clutch arm. It has either slipped out of its bracket or is bad. It is there to keep you from starting the car with the clutch engaged. A safety factor.
Why will your 1985 Pontiac trans am 305 not start with the clutch pressed - started fine earlier - acts as if the clutch is not pressed - same symptoms with and without the clutch pressed?
there is a safety switch on the clutch, it should be on the inside of the car that the pedal has to activate so the car will start, apparently that switch is bad.
Can you stop a semi truck in high range with the clutch pressed?
Not with the clutch by itself.
Toyota Tacoma clutch?
Clutch travel
How much does it cost to replace clutch on Toyota Tercel?
I replaced my clutch for about 114.00 but i get a discount. list price is probably around 150 or 175 for oem clutch kit.
What is a clutch safety switch?
It prevents engine cranking unless the clutch pedal is pressed.
Is your clutch going bad in your 1995 Toyota Paseo I have replaced master clutch cylinder and slave cylinder?
Does my 1995 Toyota Paseo have a clutch cable
Is there a Ford focus clutch safety switch?
Yes. There is a switch located behind the clutch pedal to must be depressed (when the clutch pedal is pressed all the way down) in order for the ignition circuit to be completed. Therefore the car will not start if the clutch pedal is not pressed all the way down. Starting a car while it is in gear can be very damaging to the transmission.ADDED: ... not to mention other cars and people around you!
Which pedal in a car is pressed when changing gears?
the clutch pedal
What is wrong when a clutch pedal is half pressed and at the same time the accelerator is pressed?
if I understand the question you asked correctly, I would say you are in need of a clutch but it might need adjustment but not likely.
Can an ac compressor clutch for a 2003 s10 4.3 be shimmed or does the clutch need to be replaced?
The compressor clutch does not need to be shimmed. The outside disc is pressed on until the proper air gap is achieved. If it is pressed on to far it has to be pulled off and reinstalled.
Does a 1985 Toyota supra have a hydraulic clutch?
Yes. Most Toyota cars use hydraulic clutches. That is why you have to put fluid in the clutch reservour.
