try checking the valve in the vacum brake booster. If it goes bad, it will dump your vacum and make your engine stall while pushing the brakes.
autozone.com has online manuals that give step by step how to
The torque specs for the head bolts on a 1997 Toyota Corolla goes in three simple steps: step one- tighten the bolts in the the correct order to 22lbs step two- in the same order, turn each bolt 90 degrees step three- go through and again in the same order turn each bolt in an additional 90 degree.
i also need step by step instructions on how to take off old starter and replace new one if any one knows this would be very helpful to me. thanks
Your break pads/shoes and/or rotors has to be replaced. Some rotors can be repolished and used in the future.
This website will take you step by step. Copy and paste the link below. Hope it helps:) http://www.autozone.com/addVehicleId,2145902/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c1528006f6bc
For free step by step removal and installation instructions go to the autozone.com site and go to repair manual for 1996 Toyota corolla. Be forewarned: it requires pulling the entire engine. Egads!
Step one: Check fuses and relays Step two: Check Hazard Switch Step three: Check Multifunction Switch (turn signal switch) Step four: Check Flasher unit Step Five: check bulbs Step six: check for bad wires
With Corolla stopped(this is for safety) this is how you set the clock on the 2009 Toyoya Corolla All Models. (page 148 in 2009 Corolla Manua)l Step 1 - Display the clock when the vehicle is stopped. Step 2 - Press and hold the display buttin to enter the adjustment mode for the clock. Step 3- Press the display button to adjust the minutes. After adjusting the minutes, wait 5 seconds to allow the minutes to be automatically input. Step 4 - Press the display button to adjust the hours. After adjusting the hours, wait 5 seconds to allow the hours to be automatically input. Happy adjusting 0:-)
if you have the 4afe engine it is 1st step 20ft/lbs, 2nd step 30 ft/lbs, 3rd step 44 ft/lbs if you have the 4age engine it is 1st step 10 ft/lbs, 2nd step 15 ft/lbs, 3rd step 22 ft/lbs hope that helps
it breaks
what is the step by step process for programming a key for a 2007 Toyota camry for the lock,unlock,trunk
If you call 1.800.331.4331 which is Toyota Customer service they will explain step by step