Oxygen sensor.
To replace the exhaust manifold on a 1998 Plymouth Breeze 2.0, first disconnect the battery and remove any components obstructing access to the manifold, such as the air intake and heat shield. Unbolt the exhaust manifold from the engine block, taking care to remove any remaining gaskets or debris. Install the new manifold with a new gasket, tightening the bolts to the manufacturer's specifications. Finally, reassemble any components you removed and reconnect the battery.
The EGR (Exhaust Gas Recirculation) valve on a 1997 Plymouth Breeze is typically located on the engine's intake manifold, near the throttle body. It may be mounted directly to the manifold or connected via a pipe. To access it, you may need to remove any surrounding components or covers for better visibility. Always consult a repair manual for specific details related to your vehicle's configuration.
It is located on the back side of the intake manifold. Kind of hard to get to but reachable.
Plymouth Breeze was created in 1996.
It is on the rear of the 122 CID or 2 Liter motor below the exhaust manifold.
My horn on my Plymouth Breeze was under the front manifold of the car. Have a friend or family member get inside your car and honk the horn as you listen for it. I would advise wearing ear plugs though, unless your car horn doesn't work. If it is not working then look under the manifold in the grill slots, and also maybe underneath the manifold. I have seen them there before too.
Fuel. Pressure. 96 Plymouth. Breeze
99 plymouth breeze 2.4L has 195/70 R14
A Plymouth Breeze uses ATF+4.
how much is a new computer or pcm for a 2000 Plymouth breeze
I have a 96 Plymouth breeze with 2.0 engine. Highway 44 mpg, city 36 mpg.
The battery is inside the left front fender, in front of the tire on a 1998 Plymouth Breeze.