Check for any electrical connecter behind the fuel filter housing. Check for bare wiring / shorts, exc. this may cause a short and been near the fuel filter housing it may cause fire. Be very careful and look for anything out of place/ or any thing advised.
on a 3.1 v6 it is on engine at the end of the top hose before housing,the connecter is black on sensor. on engine beside hose!!
You can't. It is nonadjustable, the idle is controlled by the computer and the idle speed controll motor. And that is screewed into the left side of the throttle body housing towards the back. It is about 3 inches long with an electrical connecter pluged into the end of it. It may be dirty. Take it out and clean it. You may have a vacuum leak too.
The blower resistor has probably failed. The connecter also likes to fail. They are located under the hood on the large black plastic housing on the passenger side. There are 4 wires in the connecter.
Yes.
Actually an electric motor is a simple device. It contains a housing, wiring, brushes, electrical connections, and an electrical coil.
There is no adjustment on a TBI fuel system, The Idle is controlled by the computer You need to check the Idle speed control solenoid. You can find that on the top left rear side of the TBI housing. It screews in, and is about 4 inches long with an electrical connecter pluged into it. Also check for a vacuum leak. If the check engine light is on then you need to scan engine with a engine scanner FIRST.
Headlight Bulb Replacement * If your going to replace the left hand light bulb remove the air filter housing * Disconnect the electrical connector unless replacing the headlight housing * Rotate the bulb holder counterclockwise and pull it out the bulb and holder assembly Headlight Housing Replacement * Remove the front bumper cover * Remove the upper headlight housing mounting bolt and pushpin * Remove the lower headlight housing mounting bolts * Pull out the headlight housing assembly and disconnect the electrical connector
Next to the thermostat housing. It has a electrical plug with two wires.
If you are referring to a ceiling fan it is in the bell housing where the fan connects to the electrical box at ceiling level.
It is inside the electrical plug at the transmission. You need to remove the battery, battery shelf, complete air cleaner housing and bracket. Once you unbolt the electrical connection you need to remove the the sockets from inside the connector housing then you can split the sockets. The speed sensor is the socket at the top of the housing (furthest away from the incoming harness)
it was originally an expansion of Auschwitz, meant as housing for forced labour. it developed into a killing factory.
temperature guage sending unit