Want this question answered?
The heat from the lighter, when placed on the surface of the stretched surface of the balloon,would melt the plastic of the balloon and allow the air inside the balloon to escape, so deflating the balloon.
Pressure inside of a balloon is created by the movement of the air molecules against the inner surface of the balloon. The more air inside the balloon, the more molecules that are hitting the same surface are, so there is more pressure.
A balloon bursts when the surface tension of the balloon's rubber is broken. If tape is put on the balloon and a needle inserted, the surface tension is held together by the tape.
If a charged rod is brought close to a gas filled balloon, one will notice a change in shape in the balloon. In short, the charge of the rod works on the molecules of the gas within the balloon and cause the balloon to elongate.Ê
Negative. Rubbing fabric onto a balloon causes an electron buildup on the balloon surface because its material has high insulative properties.
yes
The heat from the lighter, when placed on the surface of the stretched surface of the balloon,would melt the plastic of the balloon and allow the air inside the balloon to escape, so deflating the balloon.
at the part where you blow it up Take a piece of tape and place it over the outside of the balloon. Poke the needle through the tape and through the surface of the balloon. The balloon will not pop because the surface of the balloon cannot expand, thus popping the balloon.
Pressure inside of a balloon is created by the movement of the air molecules against the inner surface of the balloon. The more air inside the balloon, the more molecules that are hitting the same surface are, so there is more pressure.
The volume of the balloon would decrease. The pressure of the water would press inward on the balloon and cause it to shrink in volume.
standing surface water
Well when a balloon gets struck with a sharp object, it puts a hole in it and the surface tension is broken. The surface tension on a balloon is maxed out on the sides where the material is thin.When you poke it there is no room for it too expand.
A balloon bursts when the surface tension of the balloon's rubber is broken. If tape is put on the balloon and a needle inserted, the surface tension is held together by the tape.
No it’s standing surface water
the north pole
Yes.
nitrogen is brought to earths surface by the gravitational pull of zero gravity