STIRRUPS
Concrete is composed of cement and other cementitious materials such as fly ash and slag cement, coarse aggregate made of crushed stone, fine aggregate such as sand, water, and chemical admixtures. In reinforced concrete, steel is introduced in to the concrete. In plain concrete, no steel reinforcement is introduced. Generally tensile and compressive strength is taken by reinforced concrete and only compressive strength is taken by plain concrete
The durability of concrete is its ability to resist weathering action, chemical attack, abrasion, or any process of deterioration. The strength of concrete is the ability of the concrete to withstand pressure or force.
Tensile strength is one of the basic and important properties of the concrete. The concrete is not usually expected to resist the direct tension because of its low tensile strength and brittle nature. However, the determination of tensile strength of concrete is necessary to determine the load at which the concrete members may crack. The cracking is a form of tension failure.
Typically. I assume the salt is used for melting ice? Although exterior concrete is designed to resist damage from salt and freeze/thaw cycles, these will always shorted its life span. Better to just shovel the walk.
Inductance
Reinforcement designed to resist shear or diagonal tension stresses.
which concrete resist frost action
It depends on the kinds of stresses the structure is expected to resist. To resist cantilever stresses (bending - a combination of compression, tension, and sheer), the octet-truss is the strongest possible structure. To resist only tension a straight line, such as a cable, is the optimum structural geometry; and to resist only compression a lorimerlite framework is the strongest structural geometry.
to resist shear force
Concrete is composed of cement and other cementitious materials such as fly ash and slag cement, coarse aggregate made of crushed stone, fine aggregate such as sand, water, and chemical admixtures. In reinforced concrete, steel is introduced in to the concrete. In plain concrete, no steel reinforcement is introduced. Generally tensile and compressive strength is taken by reinforced concrete and only compressive strength is taken by plain concrete
the ability of beam or slab to resist failure in bending is called Flexural Strength of concrete.IIt is measured as modulus of rupture
The durability of concrete is its ability to resist weathering action, chemical attack, abrasion, or any process of deterioration. The strength of concrete is the ability of the concrete to withstand pressure or force.
If you mean "...to resist change in motion", that is called inertia.
The ability of a community to resist change is called stability. It is the capability of a community to resist and rebound from change.
Paints to be used on concrete should be made especially for concrete. This is a very hard surface to cover and keep covered so it is very important a paint made especially for concrete is used.
Called inertia.
it is called inertia