Q:A fault at which blocks of earth push or pull apart with one block of crust sliding up or down a sloped fault planesurface is called a? A:Fault planesurface is called dip-slip for this type of fault. P. S. J. F. M.
A fault in which the plates slide horizontally past each other is called a slip-strike fault. If it is on a plate boundary it is known as a transform fault.
cinder cone
The crust is the solid surface of the Earth.
soil creep
It depends on viscosity of the lava. the runnier the lava, the farther it flows before solidifying, so it cannot pile up as fast.
An adit. In North America, the horizontal or sloped entrance to a mine is called a "Portal". Portal more specifically refers to the portion of the shaft visible from the outside of the mine. In some areas, the Portal portion of a horizontal shaft is called the "Drift Mouth" or "Drift Portal" as this shaft leads into a "Drift Mine". With a vertical shaft, that portion would be called a "Collar".
It is called a wedge.
The nose of the car.
a slip face
They are sloped
Both landslides and avalanches are can be caused by heavy rain or snow. An avalanche is great volumes of mass sliding down a sloped area, a mudslide or mudflow also are great volumes of mass sliding down a sloped area. these are some of the similarities between a mudslide and an avalanche.
Not necessarily. A perpendicular to a sloped line will be sloped. It will be at right angles to the sloped line, though.
why PPF in economics is negatively sloped
cinder cone
Yes. Negative gradient would mean downward sloping.
A pylon perhaps?
It is called Goose rumped.This is rare, except in Quarter Horses and draft horses.
When you put the armor at an angle, the thickness is increased due to the fact that it is sloped as opposed to plumb.