Want this question answered?
cs
When the handle radius is larger than the blade radius, its a lever
A screwdriver can be considered to be insulated when the handle is constructed from a dielectric substance, which has very high resistance to electric current. This will typically contain two layers of material separating the user from the metal shaft. The metal shaft itself will be covered, as well as the handle.
Third class.
The applied force to the end of the handle is the input force and the output force is when the broom sweeps over the floor.
cs
i think a screw into a board a long screwdriver with a narrow handle
the perpendicular force applied at the end of a wrench handle. Because torque= Fd / T = F d cos θ therefore the greater the distance the greater the torque. T=torque F=force d=distance cos=cosine θ=theta
A screwdriver allows you to exert more torque on a screw. Torque is defined as the product of the force exerted and the distance from the center of rotation. Torque is essentially a rotational force. It is simple to increase torque, simply increase the distance from the center that the force is being applied, and there is greater torque without increasing your effort. The handle is made to be wide, so that a greater torque can be exerted. It is also much easier to grip a screwdriver than it is to grip a screw. That also plays a factor.
There is the tip and the handle, I don't understand 'bottom' in a screwdriver.
Some are and many are not.
the effort is where u put work into the screwdriver- the handle.
It's cheaper and lighter than a metal handle would be.
Every screwdriver has a handle. You hold the handle and turn it to tighten or loosen a screw. Sometimes your screw might be in a tight place that your hand can't get to such as inside of a car hood. You use a long reach screwdriver because the shaft above the handle is larger than a typical screwdriver. A typical screwdriver shaft is about 5 inches. A long reach screwdriver is bigger. Maybe 12 inches or 2 feet long. It's just a long screwdriver. I can't believe you would as this question
A phillips screwdriver is generally made of a steel shaft with a plastic handle
Wide handle
To prevent electrocution