answersLogoWhite

0

i need a power cord compatiable to a protron pltv -32

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Would a 125 volt cord work with a 115 volt compressor?

Yes. The cord only transmits the power. Whatever that goes in is what comes out.


What nicknames does Cord McConnell go by?

Cord McConnell goes by Rush.


How can you make your antenna stop going up and down in your 1993 accord?

Try finding the power cord that goes into the antenna and disconnect it


How many watts of peak power could the original power supply provide?

Depends on make and model. If you just open the side panel of the computer and look at the box on top were the power cord goes then it should say there.


How do you replace the power cord in a dyson vacuum cleaner?

You can find the replacement cord at www.uClean.comI believe you unscrew the top handle where the cord goes into the vacuum (unplug it first!)Then you'll see where it's connected and just unconnect the old one and replace with the newNever done it, but seen it done before.


Where is the fuse in a guitar amp?

In almost all guitar amps, the fuse is located in a small holder in the back of the amp, right next to where the power cord goes in


Does a 1997 Buick LeSabre Ltd have a block motor heater?

Some do. To check you will need to look at the side of the motor to see the power cord or the element in the block. Next time your car goes in for a oil change, have them look for the cord for you. It is easy when it is on a hoist. Mark


What cord goes into the password journal?

the one that comes with the journal


Where does the large vein at the base of the umbilical cord lead to?

the large vein at the base of the umbillica cord goes to the liver in a pig


Why is it important that the resistance of an extension cord used to power an electric heater be kept low?

An electric heater is one of the high-power appliances in a house, commonly taking 1.5 to 3 kilowatts of power. The current is high, and therefore there is a drop in the voltage applied to the heater equal to the current multiplied by the resistance of the cord. There is probably little power wasted, because any heat from the cord goes to heat up the same room. But a voltage drop causes the heater to draw less current because its resistance is constant, and therefore less total power is provided to heat the room. If the heater is thermostatically controlled so that it is not working all the time, the difference is small because any reduction in the heater's power would cause the thermostat to keep it going for longer, to compensate.


How do you reattached a garage door after the power goes out?

If you've opened it by pulling the emergency cord, then you simply reverse that action until the door top catch engages the chain trolley.


Where does the drill team and color guard go on the army ROTC uniform?

The drill team red cord goes on the left shoulder, and the color guard white cord goes on the right shoulder.