False,
Unless it is a twisted pulley system.
That's a Class-1 lever, where the input and output are on opposite sides of the fulcrum.
Yes the only thing a machine changes is force,distance or direction
A force is a vector quantity because it has both magnitude and direction.
Yes this it true, because a percent of the input energy is converted to heat, which causes the output to became less than the input.
Some of input energy is wasted in heating up the molecules, sound,etc therefore the resultent output work is always less than the input force due to loss of energy.
That's a Class-1 lever, where the input and output are on opposite sides of the fulcrum.
yes it changes the direction, and increases the force
yes.you can get 5v output even when the polarity is reversed. In a 5v battery, if u reverse the polarity, then u'll get the same 5v as output , but in the opposite direction.(i.e.,)-5v(negative 5 volt
Difference Between Alternators and MagnetosAn alternator puts out alternating current [AC]. That means that part of the time electrons flow in one direction in the wiring, and part of the time the electrons flow in the opposite direction. The number of times the direction of current flow changes direction is referred to as "cycles."Even though the output of a magneto may be in pulses, the direction of flow of electrons is always in the same direction and is Direct Current [DC].
Yes the only thing a machine changes is force,distance or direction
if only the direction changes,the input force will be the same as the output force.the mechanical advantage will always be 1.
if only the direction changes,the input force will be the same as the output force.the mechanical advantage will always be 1.
A pulley system may cause the direction of the output force to differ from that of the input force, but is not guaranteed to do so. In a simple example, a double pulley could easily result in input and output forces in parallel.
use a 3 bevelled gear arrangement akin to what is used in a car differential on the drive axle - it is possible to have a connecting shaft rotating the opposite direction to the original motion of the gears
Output. For example, if you input '2 + 2 =' in a calculator, the 4 that appears is the output.
In an op-amp, an input on the inverting terminal drives the output in the opposite direction, while an input on the non inverting terminal drives the output in the same direction. In a normal closed loop negative feedback configuration, there is feedback from output to inverting input, so that the output becomes a known function of input. So long as you stay within limits, the output will go to whatever value is required to make the inputs be the same.
A force is a vector quantity because it has both magnitude and direction.