take the battery back out
What is the answer?
Insert the ignition key into the ignition and turn it to on, the alarm should shut off.
To reset the car alarm in a 1994 Jetta, start by unlocking the driver's door with the key. If the alarm is still active, insert the key into the ignition and turn it to the "On" position without starting the engine. This should deactivate the alarm. If the alarm persists, disconnect the battery for a few minutes to fully reset the system.
To reset the alarm on a 1994 Dodge Viper, insert the key into the driver's side door and turn it to the unlock position. This action should disarm the alarm system. If the alarm persists, disconnect the battery for a few minutes and then reconnect it, which may help reset the system. Always consult the owner's manual for specific instructions related to your vehicle.
on 1998 Camry turn key on push and release alarm button turn key off then start
Check battery in remove control.
Try turning your key in drivers door to unlock, should reset the alarm
If the battery is dead the alarm will not go off
To shut off the alarm u need to stick the key in the trunk and turn it this will turn off the alarm
turn the on the door twice disconnecting battery and reconnecting works when the alarm wont shut off and is ringing
Turn your ignition switch to the auxiliary position, without starting the engine. Leave the ignition switch in the auxiliary position for 30 seconds.
To reset the alarm on a 1994 Toyota Corolla, first locate the alarm's reset button, which is typically found near the steering column or under the dash. Turn the ignition key to the "On" position without starting the engine, then press and hold the reset button until you hear a beep or see a light indicator. If the alarm continues to activate, check the key fob battery or consider disconnecting and reconnecting the car battery to reset the system. Always refer to the owner's manual for specific instructions related to your vehicle's alarm system.