Impulse is the force applied on an object multiplied by the time during which the force is applied. To illustrate the difference, a large force applied during a short time may have a lower impulse than a smaller force applied for longer.
more length more torque, force applied remains the same
When the wound is no longer bleeding, then the tourniquet is tight enough. It will need to be loosened every few minutes so as to not kill the limb it is applied to.
To perpetuate their existence by changing their goal or reason for existence, after they have achieved their original goal and no longer have a reason to continue.
The effort of a lever is the force applied to one end.The load is an object situated at the opposite end of the applied force.
It Deforms,And Its Longer A Ball. Its Just Cotton!
it is no longer in its original place
compressor blankets or,longer returns otherwise you have what you have
You may end up with less of them.
that is correct they are gone for good Strictly speaking, the term extinction is not applied to individual organisms, it is applied to a species. If there are no longer any living members of a specific species, then that species is said to be extinct. When an organism is no longer alive it is said to be dead.
Yield stress is the point at which the material is no longer linear under load; the material starts to become plastic and when unloaded will not return to its original length. Typically the yield point is defined as 0.2% offset - the value of strain that remains in the part after unloaded
Impulse is the force applied on an object multiplied by the time during which the force is applied. To illustrate the difference, a large force applied during a short time may have a lower impulse than a smaller force applied for longer.
The original Butterfingers!
Strain shows how much longer a beam becomes after applying a force in a chosen direction.Strain = change of length of the the beam / original length of the beamIn case of Shear Strain force is applied only parallel to the surface of the beam (not normal to it).The same principal can be applied not only to beams, but to other civil engineering components as well.
No they are no longer made.
The reason that it takes a moving truck a much longer time to stop than it takes a car to stop when the brakes are applied on both is because the truck weighs more. The more mass a vehicle has the longer it will take to stop.
they paint on to wet plaster so it lasts longer and sets when the plaster sets.