There is no such a thing as infinite resistance but it could be a very high resistance.
a circuit with no resistance or zero resistance can be considered as open circuit in which the current is zero. without resistance the circuit just becomes open ()
Firstly turn of the power before this test...Using a resistance or continuity tester you should get the following results:Short circuit: Very low resistance (nearly 0 ohms) or the bell will ring.Open circuit: Very high resistance (Somewhere in the range of Mega ohms) or the bell will not ring.The reason for this is because and open circuit has a gap in it (which has high resistance).The short circuit has wires that are crossed and so has a really low resistance.
It isn't. If you're using superposition, you open circuit current sources and short voltage sources; this is because the current source declares the current that will be flowing through that branch. Both current and voltage sources have a finite internal resistance.
The circuit will become an open circuit.
Nothing will happen to the resistance of the circuit. However, with the switch open, it will be 'seen' as having infinite resistance from the supply side.
The resistance goes to infinity.
The first thing you need to know is the internal resistance of the current source, the voltage source will have the same internal resistance. Then compute the open circuit voltage of the current source, this will be the voltage of the voltage source. You are now done.
Open
Replace the vent valve. Repair open, short, or resistance problem in the control circuit. Repair an open, or short, or resistance problem in the power circuit, or replace the PCM.
Yes, an infinite reading on an Ohmmeter usually indicates an open circuit. This means that there is a break in the circuit, preventing the flow of current and resulting in the high resistance reading.
In circuit equivalence, voltage and current sources are respectively equated to short and open ckt because of the very nature of them. A voltage source has zero internal resistance and current source has infinite internal resistance hence their equivalents:-)
An open circuit essentially has an infinite resistance. It is shown on digital multimeter as OL. (Open Line) A short circuit should read zero, or nearly zero, depending on the accuracy of the meter.