Want this question answered?
Made by Savage/Stevens. We have trigger guards.
It is located on the left side directly above the trigger guard
The trigger guard is available from Numrich Gun Parts. There are two different types of trigger guards for the Savage 6d. The plastic guard that has a inletted area for the trigger guard in the stock and the simple bent metal trigger guard that just screws into the stock wood. Plastic trigger guard is product # 103530U $24.10 Metal guard is product # 10543OAL $11.50
It is a lever inside the trigger guard, forward of the trigger.
This model of Savage was made from 1967-1989.If your Savage has the under lever opening in front of the trigger Guard,then it was made from 1980-1989.If not then from 1967-1979.
how to remove and replace trigger guard on Harrington Richardson topper shotgun n
e-GUNPARTS.COM
try gunstocks inc
Try ebay. I just bought a new stock for $60.I believe they had a couple trigger guards. Steve.
Iver johnson
The Stevens 84C (Stevens was owned by Savage Arms, and the 84C is the same as the Savage 4C) was made with two different trigger guards during its production life. One was a simple curved steel trigger guard that was mounted to the surface of the stock. The other was a larger cast aluminum alloy trigger guard that fit into an "inlet" (cutout area) on the stock. Both types of trigger guards are still available (in Jan 2012) from Numrich (aka Gun Parts Corp)
Installing trigger guard in H&R Topper 88 single shot shotgun. I am not a professional gunsmith, so your mileage may vary, but this is how I _finally_ got it done. 1. The "trigger extension, the trigger, and the trigger guard have to all line up together, and line up with the pin holes in the receiver when the pin is inserted. It is next to impossible to get them to line up, and keep them lined up. Before in inserted the trigger guard into the receiver, I lined up the trigger, trigger extension, and trigger guard holes. Then I inserted two small splinters of wood from either side as shims and pushed them in tight until the holes stayed lined up. I cut the splinters off even with the outside of the trigger guard. After I inserted the trigger guard in the receiver, I got the trigger guard lined up with the pin hole in the receiver, then I hammered the pin through and drove out the wedges. 2. There are two opposing springs that fit in holes in the trigger guard. The rear one goes to the trigger. The front spring goes to the barrel break release. Leave the front spring out to start. Then after you get the trigger guard back in, you can hold the barrel break release up and drop the front of the trigger guard down just enough to insert the spring through from the front of the receiver.