Click the link.
needs gaskets, or sumwere blocks cracked
yes you can. but it needs to be done right!!! you can pick up whats called block seal it fixes heads,gaskets and blocks. sometimes your better off just getting new heads.
yes
YES...Join http://www.totalrecallinfo.com for FREE to get details of ALL recalls, past and present
Might just be a head gasket. If not the Blocks Cracked. Bad.
There were some of those blocks that cracked in the main webbing.
REDBEARD ANSWER:A cracked block cannot be repaired. Either replace the engine or get rid of the car. However, if you're not certain that it's a cracked block you can check the head gasket and/or freeze plugs. In general Detroit engine blocks seem to be a little more durable than some and you don't get quite as many cracked blocks. Head gaskets however are common especially if the engine has overheated.Aluminum blocks can be repaired and welded the same as cast iron the difficulty is in the material being welded and where the crack is. Aluminum can be tig welded cast iron is more difficult as the block has to be heated to near red hot to be welded then there is a good chance the weld will not take but have done this on cast iron heads and welded with a high Nickel rod and it has held.
it is right below on the intake, on the blocks backside.
if you have replaced it and your vehicle is '''NOT''' ''Overheating'' and is '''NOT''' ''smoking''(white) you should be alright. ''usually a bad water pump if left unchange ,will cause overheating and from there you would go to blown head gaskets warped heads and cracked engine blocks and or heads.''(extreme cases)
You can find two cracked blocks at the north-east corner,then you need the bombs to break them.
Benin's flag is blocks of green, red, and yellow. Green recalls hope and revival, red the courage of ancestors and yellow is a reminder to preserve the country's wealth.
A smooth, flat surface seals better, and the head gaskets last longer. Also, a smaller combustion chamber would increase the compression ratio.