Want this question answered?
In case of measuring the wavelength of light we use Spectrometer. You could also use an oscilloscope or a dedicated frequency counter.
"sweep rate" refers to "how fast" you go through a frequency range when performing a vibration test. For example, let's put an equipment on a shaker and see how it responds to a sine excitation having a frequency between 50 and 2000Hz. The rate at which you will vary the frequency between 50 and 2000Hz is called the "sweep rate". It can be measured in Hz/min or octave/min.
This is known as the frequency of the wave.
That is called the frequency of the wave.That is called the frequency of the wave.That is called the frequency of the wave.That is called the frequency of the wave.
Period and frequency are mutual reciprocal. Period = 1/frequency Frequency = 1/period
Annually
Annually
Any equipment that is dependant upon frequency will be effected. Synchronous motors will slow down.
Yes. The instrument is referred to as a "frequency counter". It's a common piece of telecommunications test equipment.
This piece of equipment is used to convert a frequency from one channel to another. This is used in radio operations.
Resistance does not change frequency. Frequency cannot be changed without very sophisticated equipment, often called Variable Frequency Drive, or VFD, which is used in motor starters today.
Develop a cleaning schedule for a kitchen include-all equipment and chemical to be used all equipment to be cleaned include checklist any safety factors to be considered frequency of cleaning?
The frequency of a grid system is set by the rotation of the generating equipment. If you have a small generator, the frequency can be increased by increasing the speed in revolutions per minute of the engine driving the generator.
Radio communication works on radio signals that are "beamed" into the air on a certain frequency. Frequency is a certain wavelength or band. The receiving equipment has to be set to receive the signal on the same frequency.
High frequency is used because of the the size of antennas used to transmit and receive the communications signal. The higher the frequency the smaller the antenna.
That depends on the information available. You can try to measure the frequency, with specialized equipment. Or, you might measure the wavelength and the speed instead, and use the basic relationship for waves (speed = wavelength x frequency).
Christopher E. Tibbs has written: 'Frequency modulation engineering' -- subject(s): Equipment and supplies, Radio, Radio frequency modulation