0
Sounds to me like your Vacum booster behind the master cylinder is weak or bad!
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why wont the left tail light get brighter when you push the brake pedal on a 99 Chevy Blazer?
Is the bulb burned out? Is the fuse for that side brake light good? If both answers are 'yes', then perhaps you should have an automotive electrical specialist check out the problem.
How do you put my2001 Chevy blazer into 2high?
Push the button that says "2 High".
1992 Chevy s-10 blazer stuck in park?
should i push it off a cliff
How do you replace the license plate bulbs on a 1998 Chevy Blazer?
push up and turn on the housing
How do you change the brake pads on a 1997 Chevy Blazer?
take the tire off and then remove the brake caliper remove the brake pads take a c clamp and compress the brake piston replace the pads then put the caliper back on tighten the caliper bolts put the tire back on then turn car on and push on the brakes a couple of times
How do you you know if a brake booster is bad?
Start the engine and then push the brake pedal down. If it is soft and easy to push then the booster is okay. If booster is BAD the brake pedal would be hard to push.
How do you set the clock in a 2004 Chevy Blazer?
i have a 2005 blazer...there is 2 very little buttons on bottom left of the stereo..just push and hold either one
How do you replace the serpentine belts in a 1985 Chevy s-10 blazer?
Push the tensioner down and remove belt
How do you set the clock in a '92 Chevy S10 Blazer?
push the set button then within 10 seconds push the seek and scan buttons to change the time.
Why 1990 Geo Tracker brake pedal hard to press?
Hardness in the brake pedal can because by low brake fluid. Air in the brake lines can also cause the pedal to push hard.
How can you tell my 1985 Chevy Suburban needs a booster?
The break pedal will be hard to push are when you push the brake pedal all the way down the engine will start running rough are you may even here air sucking / Vaccum leak.
How do you know when your brake disc are worn?
sqeeking everytime you push on brake. or slow or hard to stop. also do a visial inspection of the brake pads
