answersLogoWhite

0

Sounds to me like your Vacum booster behind the master cylinder is weak or bad!

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why wont the left tail light get brighter when you push the brake pedal on a 99 Chevy Blazer?

Is the bulb burned out? Is the fuse for that side brake light good? If both answers are 'yes', then perhaps you should have an automotive electrical specialist check out the problem.


How do you put my2001 Chevy blazer into 2high?

Push the button that says "2 High".


How do you replace the license plate bulbs on a 1998 Chevy Blazer?

push up and turn on the housing


1992 Chevy s-10 blazer stuck in park?

should i push it off a cliff


How do you change the brake pads on a 1997 Chevy Blazer?

take the tire off and then remove the brake caliper remove the brake pads take a c clamp and compress the brake piston replace the pads then put the caliper back on tighten the caliper bolts put the tire back on then turn car on and push on the brakes a couple of times


How do you you know if a brake booster is bad?

Start the engine and then push the brake pedal down. If it is soft and easy to push then the booster is okay. If booster is BAD the brake pedal would be hard to push.


How do you set the clock in a 2004 Chevy Blazer?

i have a 2005 blazer...there is 2 very little buttons on bottom left of the stereo..just push and hold either one


How do you replace the serpentine belts in a 1985 Chevy s-10 blazer?

Push the tensioner down and remove belt


How do you set the clock in a '92 Chevy S10 Blazer?

push the set button then within 10 seconds push the seek and scan buttons to change the time.


Why 1990 Geo Tracker brake pedal hard to press?

Hardness in the brake pedal can because by low brake fluid. Air in the brake lines can also cause the pedal to push hard.


How can you tell my 1985 Chevy Suburban needs a booster?

The break pedal will be hard to push are when you push the brake pedal all the way down the engine will start running rough are you may even here air sucking / Vaccum leak.


How do you know when your brake disc are worn?

sqeeking everytime you push on brake. or slow or hard to stop. also do a visial inspection of the brake pads

Trending Questions
Why is there a strong smell of coolant coming from the ac vents on a Navigator? Where is the number one cylinder on a 99 Lincoln town car? What is the bolt pattern for a 1979 Pontiac Bonneville? Bad ignition module is also causing of not starting? What is a cylinder engine sequence? Did Chevy make a 1958 El Camino? Carburetor on 94 suburban? Why does 2001 Chevy Malibu keep shutting off while driving after on the road about half an hour then restart after 10 minutes then repeat same process all over again? Where can I find the heater core and diagrams - pictures of it for a Ford Taurus - Mercury Sable? Gear ratio in 2002 Chevy Silverado? Chevrolet 2000 single cab 4x4 manual shift and recently while driving if you let off the gas to slow down before a stop and even before you apply brakes the truck is making an awful chattering noise? Why is the engine light on 2001 Ford Taurus on 106000 miles? Why does a 1990 Oldsmobile Ninety Eight die at stop lights but starts back up so far? 1997 Tahoe 5.7L with a KN cold intake kit installed am experiencing an interruption or hesitation or gas splutter at 90 to 120 Kph Ive changed the plugs and wires but still have this problem? How long should it take a mechanic to change spark plugs and wires on 2002 Pontiac sunfire? Do 22 rims from a Crown Victoria fit on a 97 Chevy? What if your 98 s10 blazers heater is stuck on How do you fix it? What is the mpg on a 1993 Chevrolet S10 Blazer? What type of coolant do you put in dodge ram truck 1999? What is the fix for an odb2 code P0121 on a Chevy S-10?