0
behind the crank pulley
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the Gm 3800 series 3 crank position sensor located?
Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor
Crank Position Sensor on 1990 3800?
behind the harmonic balancer pully on thr right side of the engine
Where is the knock sensor on a 1992 Buick Regal 3800?
Where is the knock sensor located on a 1992 buick regal
What causes a 1992 Buick 3800 LeSabre not to have spark after changing the F-Pump and crank sensors?
check the wiring goig to the crank sensors and check and see if you can adjust the gap on the outside sensor maybe its not properly connected
How crank position sensor work?
On the 3800, its a simple optical gate, that reads the teeth in a toothed wheel. If you crack open most ball-mice, they work on the same concept.
How do you locate the crank position sensor on a 96 firebird V6 3800?
el sensor esta localizado encima de la polea del cigueñal a una pulgada por arriva de la polea
Where is the oxygen sensor on a 1990 Buick Le Sabre 3800?
The 1990 Buick LeSabre oxygen sensor is located on the outside of the air cleaner housing. The oxygen sensor will be on the back side of the housing.
Where is the control temperature sensor on a 92 pontiac bonneville 3800?
I have a 92 Buick Riviera 3800. The temp sensor on my car is just underneath the throttle body... driver's side of the engine
Where is the crankshaft sensor on 2000 Buick Regal 3800 V6 and how do you change it?
The sensor is located in between the crank pulley and front cover, just to the lft of the crankshaft. In order to change the sensor, you must, first, remove the crank pulley. With the damper off, unplug the sensor, and pull off the plastic cover. The sensor is mounted with 2 bolts, just to the left of the crankshaft. You'll need a deep 15mm socket.
How do you change the crank position sensor on a 1998 Grand Prix GT 3800 series II?
Remove the drive belt, remove the crank pulley (need a special puller for this), remove the plastic shield, and finally remove the two bolts that secure the sensor to the engine. This is all done through the passenger side wheel well with the wheel removed.
Where is the camshaft position sensor on a 1997 Monte Carlo?
Depends on the engine. On the 3.1 and 3.4 it is located on the front of the engine, up top, but below the power steering reservoir. The connector for the sensor is located behind the alternator. On the 3800 it is located in the front cover above the crank balancer pulley.
What would cause a buick 3800 to not start after it has warmed up?
has the same problem with a 92 Pontiac bonniville with the 3800 ended up being the cam position sensorI justot work.
