0
What else can I help you with?
Buick 3800 crank position sensor?
behind the crank pulley
Where is the Gm 3800 series 3 crank position sensor located?
Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor
What is the setting for a crank prosion sensor on a 1990 olds 88 3800?
The setting is you better have good eyesight! It has to be positioned between the fins on the back of the cranshaft dampner.
How crank position sensor work?
On the 3800, its a simple optical gate, that reads the teeth in a toothed wheel. If you crack open most ball-mice, they work on the same concept.
How do you locate the crank position sensor on a 96 firebird V6 3800?
el sensor esta localizado encima de la polea del cigueñal a una pulgada por arriva de la polea
What is the procedure for changing the crank sensor on the 1989 Buick Reatta with the 3800 engine?
To change the crank sensor on a 1989 Buick Reatta with the 3800 engine, first, disconnect the negative battery cable to ensure safety. Locate the crankshaft position sensor, which is typically found near the crankshaft pulley at the front of the engine. Remove the wiring harness connector and the mounting bolt to take out the old sensor. Install the new sensor by reversing the removal steps, ensuring it is securely fastened and the connector is properly attached before reconnecting the battery.
Where is the oxygen sensor on a 1990 Buick Le Sabre 3800?
The 1990 Buick LeSabre oxygen sensor is located on the outside of the air cleaner housing. The oxygen sensor will be on the back side of the housing.
How do you change the crank position sensor on a 1998 Grand Prix GT 3800 series II?
Remove the drive belt, remove the crank pulley (need a special puller for this), remove the plastic shield, and finally remove the two bolts that secure the sensor to the engine. This is all done through the passenger side wheel well with the wheel removed.
Where is the camshaft position sensor on a 1997 Monte Carlo?
Depends on the engine. On the 3.1 and 3.4 it is located on the front of the engine, up top, but below the power steering reservoir. The connector for the sensor is located behind the alternator. On the 3800 it is located in the front cover above the crank balancer pulley.
Where is the crank sensor on 3800 series II engine---Specifically a 1996 RS Chevy Camaro?
Right above the crankshaft pully and balancer on the timing cover...
What causes a 1992 Buick 3800 LeSabre not to have spark after changing the F-Pump and crank sensors?
check the wiring goig to the crank sensors and check and see if you can adjust the gap on the outside sensor maybe its not properly connected
Location of a cam sensor on a 1989 Oldsmobile delta 98 3800 v6?
The camshaft position sensor is located behind the water pump pulley. If looking directly at the pulley, it is at about the 10 O'clock position. TechJK ---------------------
