It can be done... I need to do some reading to figure out the how, as I'm not sure if the MBN series C15s ran all that stuff through a chassis node or not.... if it did, then some CECU programming will be required.
To install a manual fan switch in a 2005 Peterbilt 379 with a C-15 engine, first, locate the fan relay in the fuse panel. Disconnect the battery to ensure safety, then wire a toggle switch to the relay, connecting one terminal to the relay's control wire and the other to a power source, such as the battery. Mount the switch in a convenient location inside the cab. Finally, reconnect the battery and test the switch to ensure the fan operates manually.
Try a Peterbilt dealership.
The flasher unit is integral to the switch.
First, you have to change the ECM settings.
It's just a weatherpack terminal. Literally a plug and play device.
ac and heating fan control switch is needing replaced. I need to know how to remove and re install new one on a 2005 chevy silverado Z71.
Pressure switch on a 2005 Chrysler 300 C can be changed by removing the wires from the switch. Remove the retaining nut. Reverse the process to install the new switch.
A 2005 Peterbilt typically uses R-134a refrigerant in its air conditioning system, which generally holds around 2 to 3 pounds of refrigerant. However, the exact amount can vary depending on the specific model and configuration. It's always best to refer to the owner's manual or a service manual for precise specifications. Regular maintenance and checks can help ensure optimal performance of the AC system.
The 2005 Peterbilt M 11 Cummins diesel engine map sensor is located next to the fuel pump. The map sensor should be labeled as such.
Look in the owners manual. Sometimes there is a button or switch that will let you do it and it will tell you where.
Chevrolet does not install fuel pump inertia switches on their vehicles.
Not sure if this helps or not but on a 2005 Toyota Sienna LE, the dash-light dimmer switch is actually the trip odometer reset switch. Turning the trip odometer reset switch left or right controls the dash-light levels. Had it not been for the factory manual, and Google, I would have never known this.