UK answer only: Yes but you need a three-pin to two-pin adaptor. Alternatively fit a three-pin plug to the light and leave the earth pin disconnected. This can only be done if the lamp already has a two-wire cable fitted to it, anything else is potentially dangerous.
es as long as you use the correct terminals internally and the lights are fit for purpose i.e. Are set for the domestic electrical current of your mains supply.
A three cord line should not be attached to a two pin plug unless the cord has a two pin plug on it and the three pin ins two to three pin plug adaptor as these are configured to ground the earth line
Depends on the size of the wire in the extension cord. The 3 prong is just the hot, neutral, and ground.
I don't know about an extension cord, but they do sell plug adabters. You can pick them up at any hardware store or even Wal-Mart. They are ussaully grey or orange , and look like the plug end of the extension cord. One end will have the 2 prong, the other side will have the slots to plug in the three prong.
Yes, as long as the extension cord is rated for the load. Most microwave ovens use 1000W or more, some less. A standard two wire extension cord would be unsafe. There are, however, extension cords which have the proper gauge of wire and the necessary 3-prong outlets which a microwave would need to operate safely.
Light and an extension cord. The extension cord will act as an added resistor in series. The more cord you add will only increase the overall resistance from the wall outlet. If you use a high gage extension cord, this will help reduce the resistance. But any cord will add resistance. If the gage is low, then the cord will actually heat up and you will be able to feel the heat. That is due to the resistance within the cord. Check out my sketch of how I perceive your Q: Chord + drop light w/chord ]---------------(]--------O Versus drop light w/chord ]--------O
Change either the plug or the cord. The fourth prong is another ground. It would be easier to change the cord.
Depends on the size of the wire in the extension cord. The 3 prong is just the hot, neutral, and ground.
I don't know about an extension cord, but they do sell plug adabters. You can pick them up at any hardware store or even Wal-Mart. They are ussaully grey or orange , and look like the plug end of the extension cord. One end will have the 2 prong, the other side will have the slots to plug in the three prong.
form_title= Extension Cord form_header= Install extension cords in your office. What size extension cord do you need?*= _ [50] What color extension cord do you need?*= _ [50] Do you need a 3 prong extension cord?*= () Yes () No
Yes, as long as the extension cord is rated for the load. Most microwave ovens use 1000W or more, some less. A standard two wire extension cord would be unsafe. There are, however, extension cords which have the proper gauge of wire and the necessary 3-prong outlets which a microwave would need to operate safely.
You have to get an extension cord and plug them into it and then plug the extension cord somewhere in your house, if you do not have some type of outdoor outlet. You might try to get the extension cord through a window and then close the window as much as possible.
Because - the 2-prong socket is NOT connected to earth !.. Any fault in the appliance - could result in electrocution.
Just plug in all of the light sets in to the outlets on the provided extension cord.
Light and an extension cord. The extension cord will act as an added resistor in series. The more cord you add will only increase the overall resistance from the wall outlet. If you use a high gage extension cord, this will help reduce the resistance. But any cord will add resistance. If the gage is low, then the cord will actually heat up and you will be able to feel the heat. That is due to the resistance within the cord. Check out my sketch of how I perceive your Q: Chord + drop light w/chord ]---------------(]--------O Versus drop light w/chord ]--------O
You can plug an extension cord into another extension cord. A extension cord is to help make doing something easier.
A qualified electrician should make the change to a dryer connection. The best way to cheaply make the change is to change the power cord on the dryer to the three hole standard.
Grounding.
Change either the plug or the cord. The fourth prong is another ground. It would be easier to change the cord.