0
No, not at all this instruction MOV can not be used for immediate data transfer.
You will need to use command MVI Rd, 8 Bit Data for immediate data transfer.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why all the 16 address lines are not act as a data lines in 8085 microprocessor?
the 8085 microprocessor is a 8-bit microprocessor and these are bidirectional but the address lines are unidirectional.these address lines are used to address the location of the instruction in memory .these data lines are used to transfer data between processor and peripheral devices. when the address of the instruction will be recognized by the address lines the data will be send to the processor therefore the 16 address lines are not act as a data lines in 8085
What is function of hold pin in 8085 microprocessor?
The HOLD pin on the 8085 is an external request for control of the bus. Upon receipt of HOLD, the 8085 will complete its current cycle and assert HLDA (HOLD Acknowledge), and then it will float the address, data, and control bus one half clock cycle later. The external hardware is then free to use the bus. When it is done, it releases HOLD, the 8085 releases HLDA, and the 8085 takes control of the bus and continues with the next cycle. HOLD is used by external DMA controllers, such as the 8257, to transfer data to and from memory on behalf of high speed peripherals, without requiring 8085 attention to that data transfer.
What is bus in 8085?
there are mainly 3 buses are there in 8085. They are: Address bus :-Used to carry address Data bus :- Used to carry data Control bus :-Used to carry signals such as control and timing signals
What is h-L in the Intel 8085?
HL is a register pair that is used to store 16-bit data in 8085 Microprocessor
What is HL pair in 8085 microprocessor?
HL is a register pair used to store 16 bit of data in 8085 microprocessor.
What is the different between MOV and MVI in 8085?
In the 8085 microprocessor, the MOV instruction copies data between two registers, or between a register and memory. The MVI instruction differs only in that the source data is contained in the byte immediately following the opcode byte.
What is used to transfer actual data?
A data bus is used to transfer data. In Computer Information Systems in school (Dual-Enrolled)
What factors affect data transfer?
Factors that affect data transfer include: 1. availability of data 2. medium of transfer 3. speed of reception/transfer 4. protocols used for negotiation, amongst others
What is the Principles of Reliable Data Transfer?
A reliable data transfer is one that is stable . For a reliable data transfer a connection oriented protocol is used. A connection oriented protocol is one that receives acknowledgement from the receiver before sending the further data.
What is commonly used to measure the data transfer rate of a modem?
Data Transfer rate in modems is measured in Bits per second (Bps).
Which signal is used to transfer data in telecommunication?
this are radioactive wave
What is the Intel 8085?
Intel 8085 is a microprocessor that is used in various electronics devices.
