answersLogoWhite

0

A 1996 4.3 engine cannot run without the balancing shaft as it will make the engine vibrate violently. This can result is severe damage which is very costly and time consuming to repair.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Where is crank shaft sensor on 1996 chev?

Need to know what size engine it has.


Does a 1996 Honda accord have a interference or non interference engine?

It has an interference engine. The cam belt must be changed at 90,000 miles. The VTEC engine also has a balance shaft belt that also must be changed. Non-VTEC engine does not have the balance shaft belt.


Where is the turbine shaft speed sensor on a 1996 Ford Ranger?

This engine has no turbine or turbo. Although the 1996 Ford Ranger does not have a turbine or turbo, it does have a turbine shaft speed (TSS) sensor. It is located inside the automatic transmission.


Where is the balance shaft belt located on 1996 Honda Accord 2.2 engine?

It is located behind the timing belt.


Where is the crank shaft sensor located on a 1996 S10 truck with a 2.2L?

under the coil pack rr of engine block


Where is the crank shaft sensor loacted on the engine for 1996 F-250 7.3 diesel?

The crank shaft sensor is located on front of block above the harmonic balance wheel (bottom pulley on front of engine). This is easiest to get at from underneath the vehicle.


When was NS-Shaft created?

NS-Shaft was created in 1996.


When did NS-Shaft happen?

NS-Shaft happened in 1996.


How much does a camshaft cost for a simplicity?

how much does a cam shaft cost please on a vauxhall astra, 1996, 1.4litre engine size?


Where is the crank shaft located in 1996 ford explorer?

The crankshaft rotates at the bottom of the engine block ( inside / above the oil pan )


What is the lower half of 1996 318i bmw engine called?

The engine block, some refer to this as a short block. a short block refers to the block, crank shaft and pistons.


What is the shaft length on a 1996 225 HP Evinrude Ocean Pro outboard motor?

The Evinrude 225 hp Ocean Pro for 1996 was produced in three shaft lengths, as designated by engine model number CXED - 25in. CZED - 30in. STLED- 20in.