One would assume the chainsaw requires 120 volts or more if you want to run it with an inverter. If your chainsaw uses 16 amps at 120 volts then your wattage is Volts (120) x Amps (16) and that would be 1920 watts. So you will require a much larger inverter to run your chainsaw.
yes it can
It will have the potential to over drive the speaker elements and can cause distortion and potential speaker damage.
A 15 amp circuit breaker will handle this situation very well. The smallest home breaker is rated at 15 amp.
To power two 300 watt subwoofers, you will need an amplifier with a maximum power output of at least 600 watts. It is recommended to choose an amplifier with a slightly higher wattage rating to ensure that the subwoofers receive enough power for optimal performance.
Need to know the running amp draw. Starting amps would be useful l too. The average amp draw for a simple 1hp motor is about 7 amps, such as a fan motor. Ohms law says amps times voltage = watts, so 7 amp times 120v=840 watts. Consider that starting amperage is about 1-1/2 times running load, starting watts would be about 1200. You would need about a 1200 watt inverter to run that motor.
yes it can
They can be as loud, as the amp is not delivering 600 watts. The 10" sub rated at 600 watts is able to withstand more power.
1200 Watt wiring is more than enough for an 800 Watt amp. The rating of the sub doesn't make any difference to the cables. If you want to use the sub to its rated power you should get a bigger amp. If the amp can only give out 800 Watts and the sub can take 1100 Watts then you can put a bigger amp on. It is still going to be loud as with an 800 Watt amp. I have a 300 watt amp with a 1200 Watt sub and people hear me coming.
Yes, but the amp is too powerful and if turned up to full volume will blow the speakers.
It will have the potential to over drive the speaker elements and can cause distortion and potential speaker damage.
No you will not even get close to 1600 watts from that amp. If you read the spec for the amp they were putting 16-18 volts into the amp to get the claimed wattage. In your car you will be lucky to get 13.5 volts. You will see maybe 350 watts. A good rule when buying amps is a good amp will run about $1.00 a watt. So a $300 amp will be @ 300 or so watts.
I am not a sound man but an electrician. But as I understand it, speakers only receive power. So if you connect 300 watt speakers to a 250 watt amp, you can only get 250 watts out of the speakers. If this understanding is correct, this could not blow your amp. I might say, however, that in most things electrical, they are not intended to be used at maximum output for very long. So if this understanding stays true with sound equipment, then running your 250 watt amp at maximum output in an attempt to get 300 watts out of it, this could shorten the life of your amp even though you never actually overload it.
The formula for watts (or power) is Amps times voltage. Therefore with a 6 amp draw times 120 volts would be about 720 watts. A 1000 watt power inverter would do the job.
No, that's just the maximum capacity of the speakers. You can always run them at less than their maximum rating.
Standard 120 volt 15 amp outlet. 300 watts is not a high current demand.
A 15 amp circuit breaker will handle this situation very well. The smallest home breaker is rated at 15 amp.
To power two 300 watt subwoofers, you will need an amplifier with a maximum power output of at least 600 watts. It is recommended to choose an amplifier with a slightly higher wattage rating to ensure that the subwoofers receive enough power for optimal performance.