0
In North America the answer would be no. The pin configurations for voltage and amperage all differ. This is so that an under voltage or under current device can not be used on higher amperage's and voltages.
See related links below.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Can you plug in a 125 volt 30 amp plug in a 120 volt 30 amp outlet?
If the plug fits you are good to go. The typical range of residential voltage is from 110 to 125 VAC. You are fine within this range.
What happens if you put a 20 amp 250 V plug into an 50 amp 250 outlet?
You would have a code violation, only a 50 amp/250V plug would fit into a 50 amp/250V receptacle. You would not have proper overload protection, the load could (worst case) call for more amps than it is rated for and catch fire before the breaker tripped.
What amp plug should a vacuum have?
Generally, a 15 amp plug.
Can I use a 10 amp 125 volt power cord on my computer's 6 amp 125 volt input?
Sure
How many amps is 250 mA?
There are 1000mA in one amp. So there is 0.25 amp in 250 mA.
Can you plug in a 125 volt 30 amp plug in a 120 volt 30 amp outlet?
If the plug fits you are good to go. The typical range of residential voltage is from 110 to 125 VAC. You are fine within this range.
Can you plug a 120 Volt 30 Amp tanning bed into a 125 Volt 30 Amp outlet?
yes
Can you use a 20 amp 250 volt receptacle in place of 20 amp 125 volt?
Electrically yes it is safe but the pin configuration will be different.
Is it okay to replaced 4.0 Amp 250 volts w 6.3Amp 250 volts?
Not really. The 6.3 amp fuse will allow about 50% more current through the circuit than the 4 amp fuse. The extra drain may damage things.
What happens if you put a 20 amp 250 V plug into an 50 amp 250 outlet?
You would have a code violation, only a 50 amp/250V plug would fit into a 50 amp/250V receptacle. You would not have proper overload protection, the load could (worst case) call for more amps than it is rated for and catch fire before the breaker tripped.
A faulty alternator plug was replaced on an '86 F350 460 the amp meter registers backwards and smokes a little when running?
The wires in the plug are backwards. switch them around
Were do you plug your subs into?
well you plug your sub into your amp you do have an amp write
What amp plug should a vacuum have?
Generally, a 15 amp plug.
Can I use a 10 amp 125 volt power cord on my computer's 6 amp 125 volt input?
Sure
What is the circuit breaker rating required for a motor with a 250 Ampere full load current?
A motor that is rated at 250 full load amps will need 400 amp time delay fuses or a 500 amp frame breaker with adjustable amperage trips. The wire size for this motor has to be 125% of the motors FLA. 250 x 125% = 312 amps. A 350 MCM copper conductor with an insulation factor of 90 degrees C is rated at 325 amps.
How many amps can be put on a 125 amp service?
You should not load a 125 amp panel any more than 100 amps.
How many amps is 250 mA?
There are 1000mA in one amp. So there is 0.25 amp in 250 mA.
