Should work at nearly full power as long as the polarities of the 4 pin plug are in sync and it is a 3 phase 50Hz motor. Do a regular temperature check under full operating conditions for the first hour to ensure speed is enough for cooling.
Yes it can run because motors have 10% voltage variation tolerance so it can operate between 380v - 440v band.
I've checked voltage on a running motor and seen it's 440 while the supplying panel said 480VAC.
No because the motor will overblow as its over the target voltage.
No. The size of the magnetic field due to the 440V is much large than the one due to the 380V. Therefore for safety reason, it's not safe to do so.
No, that is a 30% overvoltage and the motor would overheat. The good news is that 575 volt supplies are very rare.
The correct voltage range should be printed somewhere on the motor.
Can 400Volt 50 HZ motor will bear 430Voltage/50HZ ?
no
yse
yes can run but motor only delivers 90%rated power because v/f less by 10%
The the supply stays within +/- 5% of what the motor is rated for, you can do this.
Depending on the design of the motor, it may just run with less torque/hp. It might run slightly hotter as well, depending on the load.
You can use a voltage regulator IC/transistor that can take any input voltage (to a point) and spit out whatever voltage you want, depending on your application (in this case 380 volts) then be sure you build a regulator with the correct IC/transistor. Hope this helps!
To do a motor solo run test you need to connect the motor to a power supply. Next, you observe the motor's vibration, temperature, and sounds.
yes can run but motor only delivers 90%rated power because v/f less by 10%
Depends on the motor. If it is a synchronous motor it will run too fast.
You need a 5.5kw generator to run a 5.5kw motor.
Yes it can run because motors have 10% voltage variation tolerance so it can operate between 380v - 440v band.
Yes, however, the RPM will increase by 20%, if the motor is connected to a shaft or driving something that can not handle the torque, then you might run to heating issues or performance issues.
The the supply stays within +/- 5% of what the motor is rated for, you can do this.
just connect the supply of motor to power supply..and run..then ovserve the motor sounds,temperature and vibration.
Depending on the design of the motor, it may just run with less torque/hp. It might run slightly hotter as well, depending on the load.
You can use a voltage regulator IC/transistor that can take any input voltage (to a point) and spit out whatever voltage you want, depending on your application (in this case 380 volts) then be sure you build a regulator with the correct IC/transistor. Hope this helps!
For the same power - Watts - you need to run twice as many amps at 220V than at 440V. For the same load, it'll pull half the amps at 220V than it did on 440V
To do a motor solo run test you need to connect the motor to a power supply. Next, you observe the motor's vibration, temperature, and sounds.