The the supply stays within +/- 5% of what the motor is rated for, you can do this.
yes can run but motor only delivers 90%rated power because v/f less by 10%
3 phase reverse relay can be utilized to control 480V motor 60HZ for controlling their speedspeed.
One way would be to hook it up to a supply (by itself, with no load) and measure the speed with a contact tachometer. If your supply is 60Hz, and the motor speed corresponded to one of the standard motor speeds, it would be a pretty safe bet you had a 60Hz motor. If the speed was about 20% faster than a standard speed, the motor is probably a 50Hz motor. Or 20% slower if you were running a 60Hz motor on 50Hz For instance, a 1750 RPM 50Hz motor would spin at about 2100 RPM if you ran it on 60Hz.
It is an extremely expensive way of utilizing the deep fat fryer. You should look into changing the heating coils in the fryer to utilize the new voltage. That said it can be done.
The electrical code states that a 30 HP induction motor at 460 volts three phase will draw 40 amps. <<>> I = 33.34 AMPS IF EFF.= 95% AND P.F.= 85%
yes can run but motor only delivers 90%rated power because v/f less by 10%
The motor will run, probably at nearly the same speed, but it cannot supply the same mechanical load. If it can be run on a lighter load, proportional to the voltage, it should be OK.
You can use a voltage converter to step down the 460V 3 phase motor to match the 380V 50Hz supply. Make sure the converter can handle the motor's current requirements. It's also advisable to consult with an electrician to ensure safe and proper installation.
It will not work at all.
3 phase reverse relay can be utilized to control 480V motor 60HZ for controlling their speedspeed.
One way would be to hook it up to a supply (by itself, with no load) and measure the speed with a contact tachometer. If your supply is 60Hz, and the motor speed corresponded to one of the standard motor speeds, it would be a pretty safe bet you had a 60Hz motor. If the speed was about 20% faster than a standard speed, the motor is probably a 50Hz motor. Or 20% slower if you were running a 60Hz motor on 50Hz For instance, a 1750 RPM 50Hz motor would spin at about 2100 RPM if you ran it on 60Hz.
This should not be a problem but check with the manufacturer of the laundry equipment to be certain.
It is an extremely expensive way of utilizing the deep fat fryer. You should look into changing the heating coils in the fryer to utilize the new voltage. That said it can be done.
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
Not advisable, the voltage differential is too great.
The electrical code states that a 30 HP induction motor at 460 volts three phase will draw 40 amps. <<>> I = 33.34 AMPS IF EFF.= 95% AND P.F.= 85%
To run a 380VAC 3-phase 50Hz motor on a 220VAC 3-phase 60Hz supply, you would need to use a voltage converter to step up the voltage from 220VAC to 380VAC. Additionally, you may need to adjust the motor's parameters to account for the difference in frequency between 50Hz and 60Hz, such as adjusting the motor's speed rating and ensuring the motor does not overheat due to the increased frequency. It's important to consult an electrician or motor specialist to ensure safe and proper operation.