No, that is too much.
No, the voltage difference is too much. A 570 volt motor falls in the 600 volt range which is separate from the 480 volt range of three phase systems.
No. The voltage rating needs to be 600 volts for 480 volt power.
If they are in different rooms or side by side in the same room, and not connected together mechanically, there should not be a problem.
You cannot run a three phase motor on single phase power. You'll burn the motor up within minutes. By the way, I've never seen or heard of a 380 volt motor. Do you mean a 480 volt motor? If so, the only way you can power it is with the correct full voltage and a 3 phase power supply.
i have 200 hp motor what i need cable size in 100 feet distance
No, the voltage difference is too much. A 570 volt motor falls in the 600 volt range which is separate from the 480 volt range of three phase systems.
Can I run 480 volt , 60 HZ motor at a 380 volt , 60 Hz system?
No. The voltage rating needs to be 600 volts for 480 volt power.
Yes, but the 600 volts would have to be transformed down to 480 volts. Direct connection to the motor with 600 volts would overheat the motor to destruction.
the motor having voltage rating above 480 volt is hv motors and motor having rating below 480 volt is lv motors. generally motor above 185 kw is hv or mv motor and motor below 185 kw is lv motor.
Depends on the motor and the load on that motor. If the motor is loaded to its capacity, it will draw the same amount of power as it would on 690 volts - which will result in ( 690/480 = ) 144% of normal current, which will thermally damage the motor, or will trip overload protection.
Inspect all motor labels and see if they are dual voltage motors. If they are, they should have a label on them telling you how to convert the motors for 480 volt. This is a relative simple task. Converting to 480 volts will lower the motor current to half of the 230 volt rating, so you will have to change the overload heaters in the individual motor starters. You need to do this to protect the motors in case of overloading. Last the control transformer will need to be reconnected for 480 volt.
If they are in different rooms or side by side in the same room, and not connected together mechanically, there should not be a problem.
You cannot run a three phase motor on single phase power. You'll burn the motor up within minutes. By the way, I've never seen or heard of a 380 volt motor. Do you mean a 480 volt motor? If so, the only way you can power it is with the correct full voltage and a 3 phase power supply.
The systems are one in the same. Yes.
i have 200 hp motor what i need cable size in 100 feet distance
1.73*480*22