It can, but some modifications have to be done. It's actually a common thing to do to put a 6 bolt head (head from an eclipse produced from 89 - mid 91) from a 1g eclipse (1st generation) into a 2g eclipse (2nd generation) due to several benefits. If its a head from a mid 91- 94, then its pretty much a direct swap.
will a 91 Mitsubishi eclipse body parts fit a 91 ford probe
No, it is not standdard
Yes it should fit the frame not sure if tank will fit as the 91 barrel and head are bigger
No, a 91 metro transmission will not fit in a 98. A 91 will fit any metro between 1988 - 1996 though. After 1996 a lot of Metro's became 4 Cylinder which made them different from the previous generation metros. It may fit if the engine sizes are correct (1.0 litre 3 cylinder to the same but do not mix and match).
No, it will not fit.
If we are talking about valve lifters, remove cylinder head and pushrods and lifters will be excessable.
nope
May only be able to fit in an open end wrench.
Should be a direct fit. I don't take they changed anything till 2000 engine wise The 1991 had a coolant sensor at the rear of the head that the 1997 head will not have a hole for.
Any type of socket can be used to remove a 91' Cavalier wheel cylinder bolt that looks like a reversed torx. However, make sure the socket is a bolt head socket.
a 4.0 is a six cylinder engine
uhhh can you be a little more specific?