0
No, the only way would be if the belt wasn't driving the alternator causing low voltages to the electronic transmission.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Can a broken engine oil dipstick cause hard shifting?
a broken dip stick wont cause hard shifting... the engine does not do the any shifting... your problem would be the transmission... check transmission....
What would cause squealing on driver side of kia sedona when accelerating?
idler pulley. Change it now before the serpentine belt breaks. Hard job to do I think?
What could be wrong with a Mercury Tracer that stalled out then started smoking and steering hard?
A broken serpentine belt.
Will a weak battery cause new serpentine belt to squeak?
No, the battery has nothing whatsoever to do with the belt other than the belt is driving the alternator which recharges the battery. The alternator is working hard to recharge a weak battery. If the belt is squealing then the belt is either worn out or it is loose. If it is loose it is because the tensioner is defective and not holding the proper tension.
How do you adjust the tension on a serpentine belt on a Pontiac Grand Am?
The belt tension should adjust automatically. There's a thing called a belt tensioner that has a strong spring in it (you can't see the spring) that keeps pressure applied to the belt. This belt tensioner is what makes the serpentine belt so hard to remove. Many times the tensioner is in a difficult place access.
What can too much clutc pedal play cause?
hard gear shifting
What is causing your 1991 Oldsmobile Cutlass Supreme to overheat when you drive and make the steering wheel really hard to turn?
The serpentine belt is broke or loose. Replace the belt
What can cause hard down shifting in dodge 2003 caravan?
Bad Throttle Position Sensor
How hard is it to replace a serpentine belt on a ford explorer?
It's not hard at all. All serpentine operate in a similar way. You will need to use the diagram on your truck to figure out which of the pulleys is the tensioner. Then simply loosen the tension on the belt with a wrench or socket driver and remove the belt. Then repeat the process of loosening the tensioner to install the new one. Just make sure that you run the belt around the pulleys in the proper way by following the diagram.
How do you change the water pump on 2002 Cadillac Escalade?
Not too sure, but I have an '03 that I'm going to replace the water pump, ac belt, and serpentine belt on. Can't be that hard, right?
Can you put too much transmission fluid in your vehicle?
Yes, overfilling can cause the fluid to aerate which can cause leaks and hard shifting.
Why is your 2004 Chevy Malibu hard to steer at idle or low speed?
check the serpentine belt tensioner for being bad, it might not be keeping the drive belt tight enough against the pulleys.
