answersLogoWhite

0

If we are talking about a clutch slave cylinder for a standard transmission, yes it could.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do I bleed the slave cylinder on a 2006 PT Cruiser?

I had to punch a hole in the diagram/plug then use a screw to stop the flow and bleed the slave through a pee hole in the port!


How do you stop gas from going into a cylinder?

I don't know why you would want to stop gas from going into a cylinder, but there is only one way i can think of. If it is a fuel-injected vehicle, you can disconnect the fuel injector harness from that cylinder, that will stop the injector from firing. If it is has a carb, I don't think there is a way.


How do you know if its the clutch master cylinder or the slave cylinder thats broken on your 92 ford ranger Its still runs but wont move at all it just started going slower and slower and then it stop?

This sounds like it is the clutch itself, not the master or the slave. If you can put it in gear and it doesn't move, it has to be the clutch worn out. If it were the master or the slave, it would grind when you tried to put it in gear.


What can cause the radio to stop working in vehicle because a adapter was plugged into the electrical outlet?

Check the fuzes.


Would the spark control modulator cause a vehicle to stop running when idling and not start back up?

no


Why is it important to be certain that vehicle's brakes are working properly?

Because if the vehicle can not stop it will hit things and cause damage and injury. Indeed it could kill someone.


How do you bleed the clutch slave cylinder on a 1986 Ford Ranger?

well mines not a ranger its a ford f250 super cab 7.5 l now how do i stop the clutch pedle from going to the floor


Why should one not stop their vehicle in tunnels?

It would cause an accident. People do expect to have a car stopped in a tunnel.


If a police patrol car police randomly stops in back of you do they automatically run your plates or do they only stop you if you have a driving violation?

In many jurisdictions, police enter most plates they stop in front of through the data base, but unless you have a warrant on the vehicle, they still need probable cause to pull you over. Better answer is it depends. A Police Officer has discretion and may or may not run your plate. You may have a warrant on the vehicle or a invalid driving status. Those two reasons are enough to stop the vehicle. Furthermore, Probable Cause is not necessary to stop a vehicle. The level needed is Articulable Suspicion and is a lower degree of certainty than Probable Cause.


93 ford escort 4eat trans erratic shifting what causes this Trans has been serviced. shifting problem only in forward. Shifts fine at one stop light go to the next light and will not shift up.?

it may be the slave cylinder or clutch master cylinder


What could cause the speedometer to stop working on a 1992 acura legend?

You have a bad Vss Sensor.............. The vehicle speed sensor.


What would cause a truck with a manual transmission to stall when slowing down to a stop?

vehicle is still in gear, step on clutch