0
If it's not disengaging like its supposed to. See if it's retracted from the flywheel after it is started.
NEW ANSWER: NO it will not, The starter has nothing to do with the way the engine runs. The starter only turns the engine over so it will start. If the starter is draging then you do need to replace it.
What else can I help you with?
Y does the rear ac make a poping sound when its on?
rear blend door motor is bad rear blend door actuator motor is bad
Can a run capacitor start a blower motor running it slow and causing it to overheat or is it a bad motor?
Yes, a bad capacitor causes blower motor to become slow or stop. Since bad or shortcapacitor will make the surge of current and tripping of circuit breaker.
Did General Motors make a bad motor mount on the Oldsmobile Ninety-Eight?
It is possible, but there were no recalls relating to motor mounts.
Why does blower motor make a loud noise on a 1995 Chevrolet when turned on high?
Maybe a bad bearing in fan motor
Why does the fan motor make noise in a 1983 Chevrolet Camaro?
The bushing are bad.
Would a bad motor mount make a car shake violently?
yes
How can you tell if the starter is going bad on a 1993 4-door 4.9L Cadillac?
You know the starter is going bad when you have a dragging starter.
What would make the power window on a 2002 ford expedition stop working?
Bad motor, Bad switch, Broken wire,
2001 Pontiac grand prix heater not blowing?
Bad blower motor fuse? Bad blower motor resistor pack? Bad blower motor - checck to see if it is getting power--if so bad motor Bad switch?
What does it mean when your car makes a dragging noise and it seems to be on the left side?
Bad wheel bearing.
When was Bad Motor Scooter created?
Bad Motor Scooter was created in 1973.
Why are fuses blowing for the heater on 2002 Pontiac sunfire?
I can't give you a real specific answer, but fuses blow because something is drawing too much current. The major electrical part of the heating system is the blower. There might be a shorted winding in the motor, or maybe the motor bearings are going bad and are dragging. This can cause an over-current condition too. I suspect you need to replace the motor.
