You can do this with something like a storm water pipe. Storm water is basically clean and there is unlikely to be any problem with build up of sludge in the pipe. You should not do it with sewerage pipe as it will cause it to block up eventually
If you are asking about the correct gradient. It is 1:40 (meters)
The item used under the shower pan to create the slope for the drain is called a "shower pan liner" or "shower pan membrane". It is typically made of PVC or CPE (chlorinated polyethylene) and is installed over the subfloor and around the drain to create a waterproof barrier. The liner is then sloped towards the drain using a combination of techniques, such as sand or mortar beds, pre-sloped foam panels, or adjustable slope systems. The choice of method depends on the specific requirements of the installation and the installer's preference. Once the liner is in place and sloped properly, the shower pan can be installed on top of it, and the tile or other finish material can be applied. Proper installation of the shower pan liner is crucial for ensuring that water drains properly and does not seep into the subfloor or surrounding areas, causing damage or mold growth. HydroBlok systems are known for their durability, water resistance, and ease of installation. They can be used for both residential and commercial applications and are suitable for a variety of finishes, including tile, stone, and vinyl.
You should try to limit the number of downspouts. The number is really determined by the length of gutter run. If the length is over 25-30 feet you may need a downspout at each end. Otherwise you would not be able to get enough pitch or slope on the gutter for it to drain properly. Aslo look to place downspouts where the excess water can easily drain away the house and foundation.
Protractor or bevel gauge.
when we look at the curve ,, we can see that before the peak point curve has greater slope as compared to the slope after the peak point .. the reason is PL is given as I^2RL ,,, current is a squared term here . before peak point current is greater so overall change in power is much greater but after peak point RL is greater and current is less now the load resistance is not a squared term... so slope will be less. therefore the curve is not symetrical
how the values of the slope affect the overall meaning of the equation?
One quarter inch per foot is standard "slope". This equates to a quarter bubble on a level. If you don't have at least one eighth of an inch "slope", your drain will not work properly and will clog constantly.
With a level
1/8 " - 11/2".
The maximum number of drainage fixture unit on a 2" drain line depends on the slope of the drain line. 21 units are allowed if the slope is 1/4' per foot, and 26 units are allowed if the slope of the line is 1/2" per foot.
Due to slight slope.
Only if the people want the contents to flow back or forward.
If you are asking about the correct gradient. It is 1:40 (meters)
tile should slope sightly down toward the drain and drain should be recessed slightly below the top of the tile
Make sure you have a correct slope going the right way.
Add a center drain or slightly slope towards the outside.
All drains slope 1/4 inch per foot, minimum. Too much slope,though, can mean pulling water out of the trap or goose neck on a toilet.