The easiest is to align the object with the earth's magnetic field and pound on it with a hammer, but this is slow. Another is to rub one pole of a magnet repeatedly in the same direction along it. The fastest is to place it inside an electromagnet solenoid and power the electromagnet from a DC power source.
first, you have to have a ferromagnetic core, like an iron bolt. then, you wind a magnetic wire around it. the thicker the winding, the stronger the magnet. the tips of the wire should be protruding so you can connect it to a source. skin the tips of the wire, too. connect the wire to a dc source and you got an electromagnet.
Motors that do not have magnets work exactly the same. The permanent magnet is replaced by a electromagnet, which is a coil of wire with a voltage applied to it. This electromagnet is what produces the magnet field necessary for a motor to operate. It is just easier and lighter to use this style of DC motor in larger applications.
A cell or other (DC) power source must, indeed, be connected to an electromagnet to make it work. It is an electromagnet. Surf the link to our friends at Wikipedia. It's a good article, and the pics are cool.
Trsansformers work on mutual induction principle caused by the changing magnetic field. Since there is no changing magnetic field i.e there is no "+" and "-" cycle in DC source supply so transformer cant work on a DC source. Its core will become permanent magnet.
Not usually. But this depends on how the motor is made. So a permanent magnet motor is usually a d.c. Motor. It's something to do as with the wires in the motor, the electromagnet-outer fields are wound.
Yes true. Even without the iron core as current passes through the coil then the coil would act as a magnetic shell. If the wire is wound in a helical form, then the device is known as solenoid. So with the current in the solenoid it would act as if a bar magnet. If iron core is introduced then the magnetic lines would be concentrated and hence an intense magnet could be produced. The pole of this system will be determined by using 'end rule'.
Either AC or DC will do it, but usually a DC source (battery or rectified AC) is preferable, as the North and South poles won't keep changing ends
To turn a piece of iron into a temporary magnet, wind a coil of (insulated) copper wire around it and run a DC current through the wire. The iron will become the core an electromagnet -- the one you just constructed. As long as direct current flows through the coil, the iron core will attract ferromagnetic materials.jkghyjy Wrap many coils of lacquered copper wire round an iron nail. When electricity is sent through the coils, the nail becomes magnetised. The iron is an electromagnet as long as the power is on. When a piece of iron is brought near the magnet it also becomes a temporary magnet.
The flux density of an electromagnet can be easily controlled. It's also easy and cheap to produce a large flux density with an electromagnet which is necessary for such large dc motors. Permanent magnets are generally expensive. For such a large motor,a very large permanent magnet will be needed for that motor which will not be ideal.AnswerElectromagnets are more powerful than temporary magnets, and -as pointed out above- their flux density can be controlled.
Exposing a magnet to a DC magnetic field typically won't demagnetize it unless the field is very strong and exceeds the coercivity of the magnet. In most cases, a DC magnetic field won't affect the magnet's strength but can alter its orientation or alignment.
scrap heap magnets are like electromagnets. electromagnets are wire coils usually raped around a soft iron core turns on and off easy . When connected to a DC voltage or current source, the electromagnet becomes energized, creating a magnetic field just like a permanent magnet. The magnetic flux density is proportional to the magnitude of the current flowing in the wire of the electromagnet. By turning on the magnet it creates a magnetic field attracting metals such as iron, nickel, cobalt and some alloys